Table of Contents
Advertisement
Setting the Funnel Height
NOTE: Before adjusting the position of funnel assem-
bly (2), ensure it is clear of any obstructions and all fluid
has been drained through the strainer.
When compressing the torsion spring (8) do not allow
the funnel assembly (2) to freely drop. This could result
in your fingers or hand being pinched between the fun-
nel assembly (2) and funnel collar (6). Always support
the funnel with one hand whenever you compress the
torsion spring (8) to change the funnel assembly posi-
tion. See F
. 4.
IG
1. When the collection container is in the correct loca-
tion for draining, set the funnel assembly (2) height.
2. Squeeze the torsion spring (8) with one hand while
you use your other hand to raise or lower the funnel
assembly (2) into the desired position.
F
. 4
IG
308667U
Usage Notes
Before you add any fluid to the drum, verify the pipe plug
(12) or drain valve (25) is installed and the drain valve
handle is closed (facing toward the drum) (F
4).
To prevent spills and/or overfilling:
•
•
Draining Fluid From the Drum
When drum is full, drain fluid by removing pipe plug (12)
(see the Evacuation System instruction manual 308719)
or rotate the drain valve handle (25) (F
points away from the drum and empty contents into an
approved disposal container.
• Always dispose of used fluids according to local,
state and national codes applicable to the
discarded fluid. Read fluid and solvent
manufacturer's warnings. For complete information
about your material, request MSDS from distributor
or retailer.
2
Sight Tube Repair Kit - 16C292
Instructions for this repair kit are included in instruction
manual 406831 (included in the kit).
Part No.
192871
122900
101818
8
6
NOTICE
Do not fill the drum above the 25 gallon indica-
tion on the site tube.
Make sure strainer (2f) (F
and obstruction free prior to use.
Description
TUBE, sight
ADAPTER, hose
CLAMP, hose
Setup
. 1, page
IG
. 2, page 4) is clean
IG
. 1, page 4) so it
IG
Qty
1
2
2
5
Advertisement
Table of Contents
