ABB EVLunic V1 Installation Manual page 7

Remove edge protection
V2 floor-mounted column example
Holder for charging cable
Document: Rev. 1.00 / Document No.: 90333 │ Date 21.08.2018
Remove edge protection
►
Remove the edge protection on the cable
opening of the column immediately before
installing the charging station (see figure).
Mounting the charging stations
►
Mount the charging stations on the
column using the enclosed screws.
Connecting and commissioning
►
Perform the electrical connection and
commissioning in accordance with the
instructions in the "Installation manual."
Mount the holder for the charging cable
(option)
►
Mount the holder for the charging cable
on the floor-mounted column below the
charging station using two screws [A].
|6