Lighter Adapter; Installation: Direct-Wire Power Adapter - Valentine One V1 Gen2 Owner's Manual

Pinch connector around power wire.
Connector plugs into red wire.
Fig 15
Acc
Direct-wire
Power Adapter
Main
Valentine One
Generation 2
Power Cord
Fig 16
8

Lighter Adapter

Articulated Bracket
Acc: Plug cord to
Concealed Display
here.

INSTALLATION: Direct-wire Power Adapter

An adapter has been provided so that you can wire Valentine One Gen2
directly into your car's electrical system. If you are unfamiliar with
automotive electrical systems, see a mechanic or car-stereo installer:
1. Valentine One Gen2 works only with negative ground electrical
systems. If your car is old, or is an unusual brand of import, make sure
it's negative ground.
2. Select a "switched" wire, i.e., one that's off when the ignition is switched
off, and has 12 volts when the ignition is switched on.
3. Position wiring-harness connector around "switched" wire and squeeze
with pliers to install.
4. Plug red wire from Direct-wire Power Adapter into wiring-harness
connector.
5. Make ground connection by clamping the end of the black wire under any
grounded screw.
6. Plug power cord from Valentine One Gen2 into the modular jack labeled
"Main" on the Direct-wire Power Adapter.
Ground
(Black)
+12VDC
(Red)
Fig 15
Main: Plug power
cord to V1 Gen2 here.
Lighter Adapter
Articulated mounting
bracket, included with the
Concealed Display, fits as
shown.