RIO ADVENTURE RA-i456 Setup Instructions

Set-up Instructions for RIO Adventure Compact Expandable Table

STEP 1: Be sure you have STEP 2: Unfold legs
one (1) frame and two (2) so feet point down
table tops, as shown. toward the floor.
To use the 27.5" x 28.5" table top only
STEP 6: Lock all four (4) corner braces.

To attach a handled trash bag:

Locate the hook-n-loop straps on one side of the table top. Be sure they are centered
in between the nubs (they slide easily into place). Thread each hook-n-loop strap
through each of the bag handles (shown in Figure 1) and reattach the straps on the
underside of the table top (shown in Figure 2).
RA-i456 Rev 12/2010
www.IntegrityOutdoorBrands.com
STEP 3: Press the buttons to
extend the other three (3)
telescopic table legs. Legs will
snap once in fully-extended
position.
STEP 7: Open the STEP 8: Begin unrolling
LARGER of the two the table top slats at one
table tops. end of the frame until it
completely flat.
See other side for instructions on how to create a 48" x 27.5" table.
STEP 4: Extend the telescoping table leg.
Use nut to loosen and tighten. Adjust to
ground slope after table is set up. Please
note there is one (1) adjustable
telescoping leg.
STEP 9: Fold the end
slats over each end and
secure by sliding the
nubs through the holes.
Figure 1
STEP 5: Splay the frame open.
STEP 10: Attach the two
hook-n-loop tabs on the
undersides of the table.
Figure 2