Receiving The Thermoelectric Cooler; Handling & Testing The Thermoelectric Cooler - Hoffman McLean Instruction Manual

RECEIVING THE THERMOELECTRIC COOLER

Inspect the thermoelectric cooler. Check for concealed damage that may have occurred during shipment. Look for
dents, scratches, loose assemblies, etc. Damage evident upon receipt should be noted on the freight bill. Damage
should be brought to the attention of the delivering carrier -- NOT to Pentair Technical Products -- within 15 days of
delivery. Save the carton and packing material and request an inspection. Then file a claim with the delivering carrier.
Pentair Technical Products cannot accept responsibility for freight damages; however, we will assist you in any way
possible.
HANDLING & TESTING THE THERMOELECTRIC COOLER
TEST FOR FUNCTIONALITY BEFORE MOUNTING THE THERMOELECTRIC COOLER TO THE ENCLOSURE.
Refer to nameplate for proper electrical current requirements, then connect power cord to a properly grounded power
supply. Minimum circuit ampacity should be at least 125% of the amperage shown in the design data section for the
appropriate model. No other equipment should be connected to this circuit to prevent overloading.
Operate the thermoelectric cooler for five (5) to ten (10) minutes. No excessive noise or vibration should be evident
during this run period. The ambient and enclosure fans should be running.
89072603
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-6046-Hoffman-TE090624010-Thermoelectric-Cooler-24V-178-BTU.aspx
© 2013 Pentair Equipment Protection - 3 -