Sullivans Sew & Go Instructions

Adjustable Height – Foldable
Many thanks for your purchase!
Please find the instructions for setting up your
Sew & Go Table.
Step #1: Basic Set Up (Figure 1)
• Remove board "H". (Figure 1A)
• Carefully cut the strap tie used to hold the leg
assembly during shipping. (Figure 1B)
• Using a Phillips screwdriver and the screws
provided, attach the two wheel sets into the
pre-drilled holes on part "F". (Figure 1C)
Step #2: Leg Height Adjustment if Used at Seated
Height (Figure 2)
• Press in the push pin (Figure 2A) and insert
part "E" leg assembly into part "D". (Figure 2A)
Repeat on each side.
• Center Tensioning Tube.
• Once the height is selected then take part "A"
and insert into part "B". Once inserted use
the push-pin to lock part "A" into part "B".
(Figure 2B) Always extend to the maximum
allowable hole. THIS ADJUSTMENT WILL VARY
DEPENDING ON THE HEIGHT OF THE TABLE.
Step #3: Individual Fine Leg Adjustment (Figure 2C)
• Remove the foot cover. Using a screwdriver raise
or lower according to floor conditions.
Sew & Go Sewing Table
Instructions
Figure 1
Figure 1A
Figure 2
Figure 2B
Item # 39276
Figure 1C
Figure 1B
Figure 2A
Figure 2C