Advertisement
Grab Handles
Kit Instructions Step 3E
Kit Instructions Step 3E
Prior to attaching the rear deck (part 22):
Remove the kit grab handles and smooth the
remaining deck area.
Align the drilling guide's groove with the inside edge
of the grab handle area and drill pilot holes using a
0.015" (0.4mm) bit.
Attach the rear deck and smooth the seam before
attaching the grab handles (etch parts 2).
Cleats
Kit Instructions Step 3E
Kit Instructions Step 3E
Seen only on the full scale set, there are 3 pairs of cleats at
the locations shown at right. Use a 0.015" (0.4mm) drill bit to make pilot
holes for the cleats and glue in place.
Rudder Tie Rods and Lower Drain Holes
Kit Instructions Step 4A
Kit Instructions Step 4A
Fold the four tie rod brackets (etch parts 6)and glue into the positions shown at
right. Insert the two tie rods (etch parts 11) and glue in place.
The drain holes (etch parts 1) may be surface mounted or used as cutting
guides (this is more accurate).
If surface mounting the drains to an R/C model, paint the kit and etch before
attaching them using RTV sealant (the blue gasket making material available
in most auto parts stores). This will allow the bond to flex as the model goes through
the temperature changes experienced by a R/C submarine.
Limber Holes
Kit Instructions Step 4
Kit Instructions Step 4
Note that the limber holes replicate the 17' (large) filming miniature.
Anneal the limber hole plates (etch parts 7 and 13) before
proceeding so that the parts will hold their shape after bending and
not try to spring back.
Remove material as shown to provide through-holes. (You can place curved plastic
following the contour of the round outer hull to simulate an internal pressure hull.)
Apply the limber hole plates as shown, aligning the lower edges of the plates to the etch
of the kit parts.
If you are building the Seaview as an R/C model, paint the kit and etch before
attaching them using RTV sealant as with the drain
holes in the previous step.
Thank you to Frank Winspur and Dave Metzner of Moebius Models for making such a great kit, their help and encouragement during the
development of this add-on set, and providing a pre-release copy of the model. Thank you to David Merriman for his guidance on making this
set R/C compatible. Thank you to Gary Kerr for his, as always, generous help on getting the details right.
ParaGrafix
Modeling Systems
"Voyage to the Bottom of the Sea"™ is © Irwin Allen Properties, LLC and Twentieth Century Fox Film Corporation. Licensed by Synthesis
Entertainment. All Rights Reserved. "The Fantasy Worlds of Irwin Allen"® is a registered trademark of Synthesis Entertainment. All Rights
Reserved. Moebius® is a registered trademark of Moebius Models. All Rights Reserved. ParaGrafix™ and PGMS™ are TM Paul H. Bodensiek. All
Rights Reserved.
2
Stern
148 Rocklawn Ave.
Attleboro MA 02703 USA
+1 508-431-9800
www.ParaGrafix.biz
G u i d e
D r i l l i n g
x36 each side
x4
6
1/8"
(0.12" - 3mm)
(0.56" - 14mm)
Remove
Bow
1
2
Remove
1
2
Fill
1
6A
6A
26
11
5/16"
Both
Sides
x2
1
13
Both
Sides
7
Advertisement
