Lavi Industries Queue Guard Installation Instructions

Germ shields for 78-inch-tall system using 80-inch-tall beltrac stanchions

Advertisement

Quick Links

Parts List:

A. Beltrac 3000 80-inch Posts
B. Queue Guard
Protective Panel
C. Panel Spacers

Tools Required:

F. Allen Wrench
To attach post base when
shipped knockdown. Included
with all knockdown posts.
STEP
STEP
1
1

Read First: Safety Recommendations

To ensure the public's safety, please follow the best practices outlined below when configuring the layout of a Queue
Guard™ barrier system.
Use Beltrac 3000 Heavy Base Posts for every
start and end post
Use Beltrac 3000 Heavy Base Posts for every
4th post
STEP
STEP
2
1

Attach Post Bases

If you received posts that were shipped knockdown, attach each base to a post. Please
refer to Assembly Instructions shipped with each post. If you received pre-assembled
posts or are using existing stanchions, please skip to Step 3.
Part No. 87-230
Queue Guard
for 78-inch-tall system using 80-inch-tall Beltrac
A
* Posts sold separately.
27810 Avenue Hopkins, Valencia, CA 91355 • www.lavi.com • 800.624.6225
Installation Instructions
Germ Shields
B
Incorporating 90-degree turns will increase the
stability of the system
Do not remove the "Do Not Lean" safety labels
affixed to each panel
Parts:
A. Post
B. Beltrac
C. Allen Wrench
STEP
1
1
Lower the post tube onto the base insert.
The bottom rim of the post tube should be flat and
flush against base.
STEP
STEP
2
1
Tilt post on its side while maintaining flush fit between post and base.
On bottom of the base: Use supplied Allen wrench (5/16 drive) to
tighten the center hex bolt until fully secured.
A SECURE CONNECTION IS IMPERATIVE: Torque until the bolt
is tight and cannot be turned by hand any further.
Check placement of post on the base and re-tighten hex bolt if
necessary. Stand post upright and position post for use.
Part No. 8X-XXXX
stanchions
®
C
Installation Instructions
Beltrac
®
Post
Rubber or Metal Base Insert
A
B
C
®
Rubber Base Insert
or Beltrac
®
Metal Base Insert
Rubber Base Insert
Metal Base Insert
STEP

Attach Post to Base

or

Secure the Connection

27810 Avenue Hopkins, Valencia, CA 91355 • www.lavi.com • 800.624.6225
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Queue Guard and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Lavi Industries Queue Guard

  • Page 1 Queue Guard Germ Shields ™ for 78-inch-tall system using 80-inch-tall Beltrac stanchions ® Parts List: A. Beltrac 3000 80-inch Posts B. Queue Guard Protective Panel ™ C. Panel Spacers Tools Required: † F. Allen Wrench † To attach post base when shipped knockdown.
  • Page 2 Confirm panel is right side up by verifying “Arrow Label” position on panel (remove label after installation). Lift Queue Guard Panel so the dovetail edges which start halfway up the frame side, align with groove openings at the top of 2 opposing Tall Posts.

Table of Contents