Page 1
Included in the Kit: 8x8 10x10 10x12 12x12 MABEL KALAMALKA OKANAGAN SHUSWAP Cedar Posts 4 Rafters 5 Headers 4 Post Caps 4 Blocks 20 Corner Brackets 8 Rafter Tails 10 *Hardware with Step by Step Instructions ...
Page 3
List of Included Hardware: 3” Lag Screws X 3” Brown Screws X Drill Bit ⅛” Pilot Hole Drill Bit x 1 of Each List of Tools Needed (Not Included in the Kit) ...
Page 4
Before setting up your new Pergola, determine the proper placement for your Posts. The measurement for the 12 x 12 Shuswap are 164”x 164”. To be sure your posts are square. We recommend that the posts are fixed to the ground, using saddle brackets (on concrete) or steel post bases. Speak with your local hardware store to purchase these, as they are not included in this kit. STEP 1: Lay post (marked A) on flat surface. Place the Header (marked C) with deep notch facing up 7 1/2” from the top. (As shown in Photo 1) Drill pilot holes with a 1/8” bit, then attach the Header to the post using Lag Screws. (As shown in Photo 2) (Photo 1) (Photo 2) ...
Page 5
STEP 2: Lift the completed assembly of the Header and Post (as shown in Photo 3), be sure to have the Header facing outward, repeat steps for the adjacent end of the pergola (as shown in Photo 4) (Photo 3) (Photo 4) STEP 3: If mount hardware is installed, position at the bottom of the posts. (Photo 5) Note: this hardware is not included, may be purchased at your local hardware store. (Photo 5) ...
Page 6
STEP 4: With deep notch facing down, lock and Screw in headers (marked B) with Lag screws, as done in step 1 to the already attached Headers (photo 6) , they should fit firmly and straight (Photo 7) (Photo 6) (Photo 7) ...
Page 7
STEP 5: Ladders. On a flat surface, position a roof rafter notch facing up. At each end, measure 5 ½” from the notch to mark where the Joist blocks will be placed (Photo 8). Once both rafters have been marked and securely screwed in using two 3” screws (Photo 8b), Space 20 3/8” between each of the blocks remaining. Repeat these steps, creating 3 ladders. FINISHED LADDER (Photo 8) (Photo 8a) (Photo 8b) ...
Page 8
STEP 6: Place the completed ladders notch down (Photo 11). Start with the first ladder snug against the edge of the post. Screw corners (using two 3” screws) of the outside ladders to the post. Screw the second ladder, spaced 20 ⅜” from the first ladder and secure at each end to the Header (using four 3” screws). (Photo 11) STEP 7: BLOCKS. Using a clamp to secure, screw in blocks to ladders (as shown in Photo 12), repeat until blocks are all evenly added next to each ladder block. (Photo 12) ...
Page 9
STEP 8: RAFTER TAILS From the inside of the ladder, screw in each Rafter Tail adjacent to the ladder blocks, with notch down. (As shown in Photos 13 & 14) (Photo 13) (Photo 14) ...
Page 10
STEP 9: CORNER BRACKETS. Secure Corner Bracket with two 3” screws (for both top and bottom). be sure to have all four corners even, top will be flush with the rafter ( as shown in Photos 15 & 16 below) (Photo 15) (Photo 16) STEP 10: POST CAPS. The final touch, top off your Pergola with the Post Cap! ...
Page 11
Talk with the Experts today! 1‐800‐830‐8033 A Thank You for your purchase RECEIVE A SET OF LED LIGHTS FOR YOUR PERGOLA FREE!!! HOW? ... Simple! All we need from you is a few minutes of your time to complete this questionnaire and emailing it as well as a photo of your Finished Pergola. The purpose of this is to get your help. We at Cedarshed want to be Sure that ALL of our valued customers are satisfied to the best of our abilities. You Will be notified when the lights are on their way! Cedarshed’s ongoing photo contest. We always love to get photos from our customers. Each year we award 3 cash prizes to our favorite 3 photos, 1st prize ‐ $250.00, 2nd prize ‐$100.00 and 3rd prize $50.00. Also everyone gets a chance to be featured in our catalogs, websites, or ads. Here are some photo tips.. 1. Take as many pics as you like. The more the merrier. 2. Move back a little, show the scenery. 3. Shoot from more than one angle. 4. Try different lighting, morning, noon, evening. 5. Add family\friends. People shots are our fav! 6. Have fun! The information you provide in this survey stays strictly with us, we will not pass it on to anyone. IF YOU HAVE ANY QUESTIONS OR CONCERNS, PLEASE CONTACT CUSTOMER SUPPORT. ...