Checking For Leaks - Blue Rhino UniFlame GBT726M Owner's Manual

Assembly Instructions (continued)
9
Insert Heat Plate and Cooking Grid
10
Lock Lid
Unlock Lid
Outdoor LP Gas Barbecue Grill Model No. GBT726M
Operating Instructions
This grill is designed to operate with a one pound 7-3/8" high disposable / 16.4 oz. propane
gas tank (DOT 39 Cylinder).
DO NOT ATTEMPT TO REFILL ANY ONE POUND (16.4 oz.) PROPANE GAS TANKS!
Connecting Gas Tank
1. Make sure the regulator/control valve is in the
"LOCK OFF" position.
2. Lubricate the threads of the regulator valve
with petroleum jelly, insert the gas tank into the
regulator valve and hand-tighten firmly.
3. Test for leaks

Checking for Leaks

Burner Connection
Make sure the control valve is securely fastened to
the burner.
If your unit was assembled for you, visually check the
connection between the burner and control valve.
WARNING: Failure to inspect
this connection or follow these
instructions could cause a fire or an
explosion which can cause death,
serious bodily injury, or damage to
property.
If the burner pipe does not rest flush to the control
valve, please contact 1.800.762.1142 for assistance.
Regulator / 1# LP Gas Tank Connection
Make 2-3 oz. of leak solution by mixing one part liquid
dishwashing soap with three parts water.
Make sure control knob is off.
Spoon several drops of solution, or use squirt bottle, at
the LP gas tank to regulator connection.
Inspect the solution at the connection, looking for
bubbles. If NO bubbles appear, the connections are
secure. If bubbles appear, you have a leak.
Loosen and retighten this connection, making sure the
connection is secure.
Retest with solution. If you continue to see bubbles
after several attempts, disconnect propane source and
contact 1.800.762.1142 for assistance.
Lighting
1. Make sure all labels, packaging and protective films
have been removed from the grill.
2. Open lid. Attempting to light the burner with the
lid closed may cause an explosion!
3. Make sure there are no obstructions of airflow to
the gas unit. Spiders and insects can nest within
and clog the burner / venturi tube at the orifice.
A clogged burner tube can lead to a fire beneath
the appliance.
4. Control knob must be in the "LOCK OFF" position.
5. Use a long lit match to light the burner. Access
the burner through the hole in bottom bowl as
indicated.
WARNING: Never lean over the grill
when lighting.
6. Turn the control knob to "HIGH"
7. If ignition does not occur in 5 seconds, turn burner
control knob OFF, wait 5 minutes and repeat
lighting procedure.
8. After lighting, observe the burner flame. Make sure
all burner ports are lit and flame height matches
illustration.
CAUTION: If burner flame goes out
during operation, immediately turn
the gas "OFF" and open lid to let the
gas clear for about 5 minutes before
re-lighting.
LOCK
OFF
PUSH
TO
TURN ON
MED
LOCK
OFF
PUSH
TO
TURN ON
MED
Match
1/2"
Flame
12.7 mm
1/4"
6.4mm
0"
0mm
Proper flame height.