California Faucets Descanso CF-TO-V3002-7 Quick Manual

CF-TO-V3002X-7 & CF-TO-V3002X-9
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure:
Maximum Flow Rate:
Operating pressures between hot and cold supplies should vary no more than 30 psi.
*
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (PRV).
†
1
INSTALLING SPOUT TO IN-WALL VALVE
•
Prior to installing faucet trim in-wall vessel rough
VALVE (1), CF-VL-R, must be properly installed
and wall surface must be completely finished
NOTE: Recommended through-hole size shall be Ø1-1/4"
•
Apply thread sealant to both threaded ends of NPT
NIPPLE (2), not supplied, and tighten into center
outlet of VALVE (1)
•
Tighten spout BASE (4) onto spout RING (5), and
slide onto SPOUT (3)
•
Tighten SPOUT (3) onto NPT NIPPLE (2)
•
If SPOUT (3) is not properly aligned when fully
tightened, turn counter-clockwise till properly
aligned
IMPORTANT: Do not overtighten SPOUT (3)
•
Push spout RING (5) firmly against wall, positioning
setscrew hole on bottom, and tighten SETSCREW
(6)
CF-TO-V3002-X_ii_190131
Descanso
CF-TO-V3002-7, CF-TO-V3002-9
In-Wall Vessel Lavatory Faucet
Installation Instructions
BY A LICENSED PROFESSIONAL
20 to 70 psi
1.2 gpm
4
3
®
*†
Ø1-1/4"
(3 holes)
2
6 5
1
1a
Pg 1