Inflation; Important - Intex Fast-Fill Owner's Manual

INFLATION

1. Plug in the AC line cord into an AC electrical outlet. See Fig (1).
2. Slide the switch left to the inflation mark (
3. When the airbed is fully inflated to the desired firmness, slide the switch right to the Off
mark ( ).
4. Lie down on the airbed to test the firmness.
5. If the sleeping surface is too hard, adjust the firmness by slowly sliding the switch right
to the deflation mark (
when the desired firmness is achieved. See Fig (5). If the airbed becomes too soft
repeat step #2 thru #5 as necessary.
Never disconnect the power line cord from the pump or from the electrical outlet while the pump
is operating. Switch OFF (
6. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
SAVE THESE INSTRUCTIONS
(150IO) AP620C BUILT-IN ELECTRIC PUMP ENGLISH 4.875" X 7.25" 06/16/2019
220 – 240 V 110 -120 V
√
). See Fig (4). Slide the switch left to the Off mark (

IMPORTANT

) the pump first before disconnecting the power line cord.
Page 3
FIG (1)
). See Fig (2).
FIG (2)
FIG (3)
FIG (4)
FIG (5)
150
English
IO
)