Page 1
User Manual 4-PERSON DOME TENT WITH AWNING ID: #05007...
Page 2
QR codes take you where you want to go quickly and easily Whether you require product information, spare parts or accessories, details on warranties or aftersales services, or if you want to watch a product demonstration video, our QR codes will take you there in no time at all.
Contents Overview ................4 Use ..................5 Package contents/product parts ........6 General information ............7 Reading and storing the user manual ........7 Explanation of symbols ............7 Safety ...................8 Proper use ................. 8 Safety instructions ..............9 Checking the tent and package contents ......11 Use ..................11 Setting up and taking down the tent ........11 Attaching the inner tent to the outer tent ......
Package contents/product parts Tunnel guide for the awning Peg, 16× Guy line, 6× (attached to the tensioning Peg bag triangles of the tent when delivered) Pole bag Entrance of the inner tent Loop and pin (for attaching the outer Tent floor tent to the inner tent), 17×...
General information General information Reading and storing the user manual This user manual accompanies this 4-person dome tent with awning. It contains important information about safety, use and care. For improved readability, the 4-person dome tent with awning will be referred to only as the “tent”...
Safety The outer tent has a water column of 2000 mm. The dimensions of the carrying bag are 57 × 18 × 18 cm. The dimensions of the ground area in the inner tent are 240 × 210 cm. Safety Proper use The tent is exclusively designed for outdoor camping with up to four persons in main- ly mild weather conditions.
Safety Safety instructions WARNING! Danger of suffocation! If the inside of the tent is not adequately ventilated, there is a risk of suffocation. − Make sure that the vents on the side of the inner tent are not covered at any time. −...
Page 10
Safety WARNING! Risk of fire and burn hazard! The tent consists of flammable material. − Do not set up any cooking or heating devices in the tent and do not hang any lighting fixtures near the walls or roof of the tent. −...
Checking the tent and package contents − Stop using the tent if the plastic parts of the tent are deformed, cracked, chipped or exhibit breaks, splinters or other damages. − Never expose the tent to high temperatures. − Never fill liquids into the tent. −...
Page 12
NOTICE! Risk of damage! Strong wind or a storm may pull the tent out of the anchors and damage it. − Set the tent up so that the wind can blow away over the tent from the back of the tent. −...
Page 13
5. Fold the two fibreglass poles for the outer tent apart and connect the individ- ual pole elements in sequence. 6. Run the two fibreglass poles with the plastic end forward into one of the two tun- nel guides on the outer tent one after another and slide them through to the end (see Fig. A and B).
Cleaning and care Your tent is now ready for use. If you would like to take down the tent, remove all ob- jects and, if applicable, dirt from the tent and perform all steps in reverse order. If you would like to fold the tent up and store it, proceed as described in the chapter “Fold- ing up and storing the tent”.
Folding up and storing the tent 2. Before taking the tent down, sweep the inner tent and the ground tarpaulin and, if necessary, remove any dirt with a damp, soft sponge or cloth using clean water or a commercially-available tent cleaner. 3.
Maintenance and repair Maintenance and repair NOTICE! Risk of damage The tent may be damaged as the result of wear. − Check the tent regularly for rips and damages to the poles, especially after a prolonged period of non-use. In the event of damage, repair the tent before you use it again.
Technical data Technical data Model: FLX – DT - 17 Category/service level: Dimensions of the outer tent (when erected): 250 × 220 + 80 × 130 cm (W × L × H) Dimensions of the inner tent (when erected): approx. 240 × 210 × 125 cm (W × L × H) Outer tent material: 185T 63D polyester with PU coating, approx.
Page 18
Great care has gone into the manufacture of this product and it should therefore provide you with years of good service when used properly. In the event of product failure within its intended use over the course of the first 3 years after date of purchase, we will remedy the problem as quickly as possible once it has been brought to our attention.
Need help?
Do you have a question about the FLX-DT-17 and is the answer not in the manual?
Questions and answers