Installation - Toro 30818 Installation Instructions Manual

132-4859
1. Crushing hazard—secure the cylinder locks.

Installation

Installing the Carrier Frame Kit
Installing the Bumpers
1. Move the machine to a level surface, engage the parking
brake, shut off the engine, and remove the key from
the ignition.
2. Loosen the jam nut on the adjusting bolt on the end of
a bumper and lower the adjusting bolt as far as it can
go (Figure 1).
3. Install the bumper to the machine frame using a large
bolt, washer, and nut from the bumper assembly; do
not tighten the fasteners
1. Large bolt (nut not shown)
2. Washer
4. Adjust the bumper so that it is parallel with the frame,
raise the adjustment bolt until it contacts the frame,
and secure it with the jam nut
3
(Figure 1).
Figure 1
3. Adjustment bolt and jam
nut
4. Bumper
(Figure 2).