Page 3
About the Instructions The Instructions is used at the date when the PAVA2240 2 Zones Integrated Voice Evacuation System Host device is developed. It contains system introduction, operation attentions, system connection instructions, product instructions and other contents of the PAVA2240 2 Zones Integrated Voice Evacuation System Host device.
Page 4
WARNING Be sure to observe the following cautions to prevent the damage to the users and others, and the damage to the equipment or property! This symbol means a “prohibition”. This symbol means a “must”. Check the damage condition of power cord. Do not block the air vent during the operation.
1. Product Description 1.1 Brief introduction PAVA2240 is an integrated voice evacuation system host. With built-in 240W digital amplifier, not only can it send out warning and alarm, but also support handhold microphone to make voice evacuation. It can manage emergency alarming, fire alarm announcement and background music playing for 2 zones.
Voice Evacuation System 2. Appearance Description 2.1 Description of Front Panel EMERGENCY STATUS AC POWER DC POWER DC CHARGE SYS STATE EMG MIC EVAC VOICE CONTROL EVAC MSG ALERT MSG STATE EMERGENCY MIC PAGING EVAC/ALERT ZONE1 ZONE2 ACK/RESET INDICATION TEST TREBLE BASS MASTER...
Page 8
Exit emergency mode: In emergency mode, press this button to exit and stop playing EVAC voice messages and zone output. Note: both the entry and exit time or mode can be checked in the "LOG" of PAVA2240. 8. Main power indicator: ...
Page 9
Voice Evacuation System circuit or short circuit; Off -- the impedance variation of the current speaker circuit is within the impedance range of the speaker when it is under modeling; 16. Background music indicator Green -- background music is running; ...
Line A Line B Primary Secondary 100V 100V 100V 100V ~220V-230V/50Hz/2A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Guangzhou DSPPA Audio Co.,Ltd. ZONE1 ZONE1 Contact Mode Contact Mode Zone 1 Zone 2 Line A Line B Line A Line B...
Page 11
Voice Evacuation System circuit cap to the right). 5. Output dry contacts of 2-channel relay Under normal conditions, the output dry contact 1 is an open circuit. When an EVAC or ALARM plays, the output dry contact open circuit becomes short-circuited. ...
ZONE1 ZONE2 ACK/RESET INDICATION Alarm enter TEST TREBLE BASS MASTER PAVA2240 Compact Voice Evacuation System Other devices PAVA2240 2 Zones Integrated Voice Evacuation System Host Fireman Microphone PAVA2200 STATUS EMERGENCY STATUS EMERGENCY POWER POWER COMMUNICATION COMMUNICATION SYS STATE SYS STATE...
PAVA2200 Fireman MIC PAVA2200 Fireman MIC This cable can be removed in branch connection way Note: PAVA2240 can support power supply for maximum 2 pcs PAVA2200 Fireman MIC. Looping and branch connection are supported. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 广州市迪士普音响科技有限公司...
Voice Evacuation System 4. Methods for examining common system failures When the digital screen displays b1, please: check if the network cable for connecting PAVA2200 is loose. When the DC POWER indicator is yellow, please: check if there input AC power ...
Voice Evacuation System 5. Installation instructions 5.1 Installation size back baffle The holes on the back of the case should be aligned Bottom view with the wall screws Cable outlet Left view Back view Right view Cover 2 Cover 1 Triangle accessory Top view...
Page 16
5. The product was once repaired or modified by others rather than the authorized personnel of the Company; Please keep the Instructions and Warranty Card properly; For any question or attentions not covered in the Instructions, please feel free to contact our dealer or visit our website at: http://www.DSPPA.com, http://www.dsppatech.com.
4P bent pin male plug 5.08MM 2P green plug 5.08MM TF card 16G Semicircle head cross belt interconnect wire M4 200MM/red wire PAVA2240 casing accessory 2 plastic post expansion pipe M6 Semicircle head cross band interface self – attack M6...
Voice Evacuation System Specifications Items Index 240W (Note: please connect high impedance speaker within Rated power output this load) Rated voltage output 100V Microphone 5mv(±1mv) Sensitivity Line input 1VRMS(±100mv) Microphone ≥70dB Line input ≥80dB Microphone 100Hz~10KHz(±3dB) Frequency response Line input 80Hz~15KHz(±3dB) The ratio of source electromotive force ≥12dB...
Page 19
Therefore, the power outlet is required to be mounted at a place where the plug of the power cords can be easily unplugged or plugged. Guangzhou DSPPA Audio Co., Ltd...
Need help?
Do you have a question about the PAVA2240 and is the answer not in the manual?
Questions and answers