Related Manuals for Eldon MCF
Summary of Contents for Eldon MCF
- Page 1 Floor standing enclosures Mild steel flange mount disconnect MCF MOUNTING INSTRUCTIONS 7697-0502-31 REV.0...
- Page 2 Roof plate Rear panel Flange door Door Mounting plate Bottom plates...
- Page 3 9/10 12/13/14/15 16/17...
- Page 5 COMBINABLE ENCLOSURE SW10 SW13 1800 525 Torque 2000 625 4.5-5 Nm...
- Page 6 MCF locking system Ref. Pic. Qty. SW10 4.2x16 M6x10 E I C I H R F I R Torque 10-15 Nm Torque 8-10 Nm STOP Torque 5.5-8 Nm...
- Page 7 MCF-Flange door Ref. Pic. Qty. M6x10 M6x12 Universal cut-out Torque 6-8 Nm Ø7 R6.4 Torque 8-10 Nm Ø7...
- Page 8 MCF-Top Panel Ref. Pic. Qty. SW19 M6x12 M12x20 Torque 15-20 Nm Torque 8-10 Nm...
- Page 9 MCF-Rear Panel Ref. Pic. (mm) <1000 >1000 M5x10 M6x12 Torque 8-10 Nm Torque 4,5-5 Nm * - Used on enclosures 1000mm and 1200mm wide.
- Page 10 Ref. Pic. Qty. St. 5.5x10 Torque 10-15 Nm...
- Page 11 MOUNTING PLATE Ref. Pic. Qty. M8x16 M8x16 2 Bottom right Bottom left < _ > right left MOUNTING Click Torque 10-15 Nm Click Torque 11-13 Nm UNMOUNTING...
- Page 12 MPD02 Ref. Pic. Qty. M5x10 Bottom left Bottom right Torque 4,5-5 Nm MOUNTING Click Torque Click 11-13 Nm UNMOUNTING...
- Page 13 Ref. Pic. Qty. M6x12 M6x16 6/8/9 6/8/9 1800 2000 Torque * - Used only on enclosures 800mm deep and above. 8-10 Nm...
- Page 14 Ref. Pic. Qty. M6x12 CCE 06 Torque 8-10 Nm Remove the cagenut. Gasket placement on top frame. CCI 06...
- Page 15 Ref. Pic. Qty. SW19 M12x25 LC 02 Torque 15-20 Nm LE 9304 Torque 15-20 Nm...
- Page 16 CCM 04 Ref. Pic. MOUNTING Click Click Click Click Note: It is mandatory for all four brackets to be installed at all four corners ! The fixation holes can be used to better fix the bracket to the frame,using cage nuts and screws !
- Page 17 Ref. Pic. Qty. Back view Click Click...
- Page 18 SW13 Torque 10-15 Nm Torque 10-15 Nm Torque 10-15 Nm...
- Page 20 6400N 10200N 6400N LE 9304 LE 9304 LE 9304 E / C E / C DIN 580 27000N 27000N LC 02 LC 02 E / C E / C...
Need help?
Do you have a question about the MCF and is the answer not in the manual?
Questions and answers