Advertisement
Quick Links
Advertisement
Related Manuals for Neilsen CT4725
Summary of Contents for Neilsen CT4725
- Page 1 INJECTOR CLEANER & TESTER PLUS PETROL FUEL SYSTEM TESTER CT4725 ORIGINAL INSTRUCTIONS...
- Page 2 The operation procedure of fuel system cleaning： Firstly, please check the car being with which kind of fuel system, carburetor system or electronic fuel injection system. Operation for the electronic fuel injection system as follows: 1. The pipeline connection of the engine Engine with fuel-return pipe Plug 1-CFS Cleaner, 2-Engine, 3-Connecting the plug,...
- Page 3 Engine without fuel-return pipe 1- CFS Cleaner, 2-Engine, 3-Plug, 4- The fuel-outlet pipe of the CFS, 5-Fuel tank, 6-Filter, 7- Fuel-outlet pipe of engine, 8-Fuel pump Disconnect the fuel-outlet pipe (E、F) of the engine, and select a suitable connector to connect the port E to the outlet pipe of the CFS. Block the other port（F）...
- Page 4 Close the valve of CFS’s fuel-outlet pipe and open the valve of CFS’s air-inlet port and then connect to the compress air. Adjust the pressure of ） by air control valve. air within 0.3 to 0.4MPa（3 to 4kgf/cm Connect the fuel supply adaptor of CFS to fuel supply pipe of the car fuel system, and open the ball valve.
- Page 5 Ball Valve Air Pressure Regulating Valve Steel Bottle Connect the TWC Flushing Kit to the output pipe of the CFS. TWC Flushing Kit Disconnect the Intake Vacuum Pipe which near the throttle and insert the TWC Flushing Nozzle into Intake Vacuum Pipe as shown. Intake Vacuum Pipe...
- Page 6 Start the engine, and open the Ball Valve slowly which be sure to make the detergent into engine vacuum pipe very slowly. The flushing process needs about 30 or 40 minutes. Keep the engine speed up to 1000 rpm and press the accelerator every 3~5 minutes to make the engine speed up to 2000 ~ 3000 rpm and keep this state for 30 seconds.
- Page 7 Put the spray nozzle kit in the throttle body as shown and start the engine. And then open the Ball Valve of fuel outlet port . Keep the engine speed up to 1000 rpm and press the accelerator every 3~5 minutes to make the engine speed up to 2000 ~ 3000 rpm and keep this state for 30 seconds.
- Page 8 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. www.cannontools.co.uk...