Galaxy DE 902682 Installation & Operating Instructions

Optimized for double ended lamps, 1000 watt

Advertisement

TITLE

DECLARATION OF CONFORMITY according to FCC Part 15

Name of third party responsible
Northwest EMC
22975 NW Evergreen Pkwy, Suite 400
Address
Hillsboro, OR 97124
Phone number
503-844-4066
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
Compliance statement
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
Part 18 compliance
This device complies with Part 18 of the FCC Rules.
This product may cause interference to radio equipment and
should not be installed near maritime safety communications
Advisory statement
equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz.
The interference potential
of the device or system
Maintenance of the system
Unplug the unit, wait 30 seconds, and plug the unit back in.
Simple measures that can be taken
Move the unit away from any radio device.
by the user to correct interference

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DE 902682 and is the answer not in the manual?

Questions and answers

Summary of Contents for Galaxy DE 902682

  • Page 1 TITLE DECLARATION OF CONFORMITY according to FCC Part 15 Name of third party responsible Northwest EMC 22975 NW Evergreen Pkwy, Suite 400 Address Hillsboro, OR 97124 Phone number 503-844-4066 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: Compliance statement (1) This device may not cause harmful interference, and (2) this device must accept any interference received,...
  • Page 2 POSSIBLE CAUSES CORRECTIVE MAINTENANCE LAMP LOOSE Make sure that the lamp is fully inserted into the sockets and that the IN SOCKETS sockets are in the closed position. INCORRECT Make sure you are using the correct input voltage with ballast. If using VOLTAGE incorrect voltage, disconnect the ballast from the power source immediately.

Table of Contents