SBC Q.RCU-D Series Hardware Installation Manual

Hardware Installation Guide
Q.RCU-D-xx Series
Product Description
The Q.RCU-D-xx series are versatile communicating sensors which
provide a user-friendly interface as well as precise temperature sensing.
Tailored for occupants, the Q.RCU-D-xx intuitive design features
coloured LED indicators to provide user feedback, rotary knobs to
adjust the setpoint offset and fan speed, and a push-button to apply
occupancy override.
As a multi-function room device, the sensor can be expanded with
a combination of up to 4 Q.RCU-D-L Light or Q.RCU-D-B Blind add-
on push-button modules, for lighting and shade/sunblind control,
making it an ideal all-in-one addition to the Room Control solution.
This document describes the hardware installation procedures for the
Q.RCU-D-xx sensors. This line of communicating sensors consists of
the following models:
- Q.RCU-D-TS
- Q.RCU-D-TSO
- Q.RCU-D-TSOF
This document also covers the installation of Q.RCU-D-L Light and
Q.RCU-D-B Blind add-on modules.
Document 26-604 | Edition ENG01 | 2016-02-15
Q.RCU-D-TS
General Installation Requirements
For proper installation and subsequent operation of the device, pay
special attention to the following recommendations:
- It is recommended that the device(s) be kept at room temperature
for at least 24 hours before installation to allow any condensation
that may have accumulated due to low temperature during
shipping/storage, to evaporate.
- Upon unpacking the product, inspect the contents of the carton
for shipping damages. Do not install damaged devices.
- The device is designed to operate under environmental
conditions that are specified in its datasheet.
- Ensure proper ventilation of device and avoid areas where
corroding, deteriorating or explosive vapors, fumes or gases may
be present..
- Do not drop the device or subject it to physical shock.
- If the device is used and/or installed in a manner not specified by
SBC, the functionality and the protection provided by the device
may be impaired.
- To ensure reading accuracy, handle sensor with care and avoid
installing on a vibrating surface.
Q.RCU-D-TSO
Make connections to the sensor last. Yanking the cable
while it is attached to the sensor can damage the con-
nector.
Any type of modification to any SBC product will void the
product's warranty.
Take reasonable precautions to prevent electrostatic
discharges to the device when installing, servicing or
operating it. Discharge accumulated static electricity by
touching one's hand to a securely grounded object be-
fore working with the device.
Q.RCU-D-TSOF