Subscribe to Our Youtube Channel
Summary of Contents for TechLogix Networx TL-SMG-4C
- Page 1 Installation Guide TL-SMG-4C 4-Button RS232 Controller www.tlnetworx.com | +1-608-960-7242 All Rights Reserved Version: 190211...
-
Page 2: Package Contents
While initially designed specifically for the TL-SM3C-HD and TL-SM3C-HDV Share-Me™ switchers, the RS232 connection plus 12 VDC power input via the PSE-1004 allows the TL-SMG-4C to be used as a standalone display controller. Features at a Glance •... - Page 3 TL-SMG-4C Install Guide I/O Layout Display Press for 3s MUTE Vol- Vol+ Press Both Tx Rx RS232 Config Display On Display Off Volume Down Volume Up RS232 and 12 VDC Connection Configuration Port...
-
Page 4: Surface Installation
2. Connect the mounting plate and any necessary spacer extensions per the drawing below. TL-SM3C Connection 1. Plug the included 4-pin cable into the bottom of the TL-SMG-4C. 2. Plug the other end of the 4-pin cable into the RS232/Power port on the TL-SM3C. -
Page 5: Standalone Connection
5. Connect the RS232 receive pin of the display to the transmit (TX) port of the 4-pin removable plug. Standalone Configuration Due to the location of the configuration port of the TL-SMG-4C, it is recommended to load the RS232 commands for standalone control before installing the device. - Page 6 TL-SMG-4C Install Guide Standalone Command Settings The following ASCII code list are the commands to define power and volume commands for the display. RS232 Command Description Feedback /SetOn:command! Display On command #SetOn:command.\r\n Length < 20 characters /SetOff:command! Display Off command #SetOff:command.\r\n...
-
Page 7: Technical Specifications
TL-SMG-4C Install Guide Technical Specifications Surface Control Interface Two (2) membrane switches Under Table Connection One (1) 4-pin removable terminal block Config Port One (1) micro USB type B receptacle Surface Dimensions 76mm (2.99 in) diameter; 2.8mm (0.11 in) tall Hole Insert Dimensions 56mm (2.20 in) diameter;...
Need help?
Do you have a question about the TL-SMG-4C and is the answer not in the manual?
Questions and answers