Toshiba 57VW9UA Service Manual page 8

LOCATION OF SCREEN AND FOCUS VR'S
To remove the Speaker grille and Front panel.
REPLACEMENT OF HIGH VOLTAGE CABLE
ANODE LEAD
RUBBER BOOT
LEAD HOLDER
Fig. a
Speaker grille
1. When replacing Anode Lead or Anode Cap with new
NOTE : THE LEAD HOLDER IS ATTACHED TO
2. Detaching Lead Holder
Z450 TPA5007
– 8 –
B G R
one, remove Lead Holder from old lead as shown in
figure below, and put it on new lead. Do not throw away
Lead Holder.
TPA5007 (Z450), BUT IS NOT ATTACHED TO
ANODE LEAD AND ANODE CAP. RUBBER
BOOT IS ATTACHED TO ANODE LEAD AND
ANODE CAP.
RUBBER BOOT
LOCK LEAD HOLDER
Fig. b
FOCUS VR's
SCREEN VR's
OLD
ANODE LEAD
or
ANODE CAP
Cut here rubber boot
and lead together to
detach Lead Holder.