Advertisement
Quick Links
2-port eSATA ExpressCard
User's Manual
Introduction .................................................................................................. 2
Important Reminders.................................................................................... 2
Getting Started ............................................................................................. 2
Installing the ExpressCard ........................................................................... 3
Verify Driver Installation ............................................................................... 4
Safe removal of the ExpressCard ................................................................ 5
Notices and Classifications .......................................................................... 6
Advertisement
Summary of Contents for Onnto T-EC2R
-
Page 1: Table Of Contents
2-port eSATA ExpressCard User’s Manual Introduction ....................2 Important Reminders..................2 Getting Started ..................... 2 Installing the ExpressCard ................3 Verify Driver Installation ................4 Safe removal of the ExpressCard ..............5 Notices and Classifications ................6... -
Page 2: Introduction
Introduction The 2-port eSATA ExpressCard enables connection of up to two SATA devices with eSATA connectors to notebook computers with a 34mm/54mm ExpressCard slot. The onboard Serial ATA2 controller increases system throughput with 3Gb/s maximum burst rate SATA devices. Please thoroughly read and follow the instructions provided in this manual. -
Page 3: Installing The Expresscard
Installing the ExpressCard Install your ExpressCard by completing the provided steps. Because the ExpressCard is hot-plug capable, the host system does not need to be powered off before installing the ExpressCard. Insert the ExpressCard into an available ExpressCard slot ensuring that the direction of the ExpressCard is aligned with the direction of the ExpressCard slot. -
Page 4: Verify Driver Installation
Verify Driver Installation Navigate to the “Device Manager” to verify that the driver has been installed. For ExpressCard without RAID management Double-click “SCSI and RAID Controllers”, if there is no yellow “!” or “?” next to the “Silicon Image SiI 3132 SATALink Controller”, the driver has been correctly installed. -
Page 5: Safe Removal Of The Expresscard
For ExpressCard with RAID management Double click “SCSI and RAID Controllers”, if there is no yellow “!” or “?” next to the “Silicon Image SiI 3132 SoftRaid 5 Controller”, the driver is correctly installed. Safe removal of the ExpressCard To safely remove the ExpressCard, click the “green arrow” icon in the system tray and select your ExpressCard as shown below. -
Page 6: Notices And Classifications
Notices and Classifications FCC-B Radio Frequency Interference Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.