Advertisement
Table of Contents
- 1 STEP-I: Unpacking and Inspection
- 2 STEP-II: Assembling the End Frame
- 3 STEP-III: Attaching the Seat
- 4 STEP-IV: Installing the Front Stretcher
- 5 STEP-V: Fitting the Remaining End Frame
- 6 STEP-VI: Hammering Dowels
- 7 STEP-VII: Inserting Brass Screws
- 8 STEP-VIII: Attaching Decorative Brackets
- Download this manual
Advertisement
Table of Contents
Summary of Contents for AuthenTeak Kingsley-Bate CH25
- Page 1 Kingsley-Bate CH25 Chippendale Garden Armchair Assembly Instructions...
- Page 2 KINGSLEY–BATE Fine Garden Furniture ASSEMBLY INSTRUCTIONS FOR THE CH–25 BACK SEAT * NOTE A TENON B MORTISE HOLE RIGHT END FRAME LEFT END FRAME STEP-I Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood. NOTE: During assembly of the furniture pleas e match all joints with the corresponding letters or numbers stamped on the furniture.
- Page 3 STEP-V Fit the rem aining END FRAME m ortise holes over and onto the BACK and the FRONT STRETCHE R tenons. Using a rubber m allet or regular ham mer with a wood bl ock between the ham mer and the wood, drive the tenons and m ortise holes together until all the joints fit snugly.
Need help?
Do you have a question about the Kingsley-Bate CH25 and is the answer not in the manual?
Questions and answers