1. Manuals
  2. Brands
  3. ESD Manuals
  4. Blower
  5. E-003
  6. Instruction manual

ESD E-003 Instruction Manual

Ionizing air blower
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

INSTRUCTION
E-003
IONIZING AIR BLOWER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-003 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ESD E-003

  • Page 1 INSTRUCTION E-003 IONIZING AIR BLOWER...
  • Page 2 Unpack the bulb and install by screwing it into the lamp socket. Replace the front panel. E-003 Overhead Ionizing Air Blower is a device of the ionizing air blower series. The E-003 blower is an overhead unit designed to provide total coverage for electrostatic problems.
  • Page 3 2.STRUCTURE...

  • Page 4: Specification

    Rotating the ionizing needle cleaning knob on time 4. INSTALLATION The E-003 Ionizing blower should be located 600 to 900mm above work surface with center fan directly above critical area. There should be no cross flow of air between unit and work surface.
  • Page 5 Drafts from air conditioning or heating air outlets can affect the performance of this device. The E-003 unit may be mounted using adjustable mounting 4.1 Mounting brackets. The mounting brackets are designed for use on a variety of surfaces such as: perforated steel angle, uninstructed metal framing and on Metro wire shelving.
  • Page 6 Setting a higher fan speed reduces time required to neutralize a static charge. When the E-003 blower is used in an electronic assembly area, the ionized air stream should cover as much of the working area as possible.

  • Page 7: Maintenance

    Away from Blower Left 300mm Center line Right 300mm 300mm 1.8sec 1.3sec 1.7sce 600mm 2.5sec 2.2sec 2.3sec 900mm 5.2sec 4.3sec 4.8sec 1200mm 8.6sec 7.5sec 8.3sec 6. MAINTENANCE To clean ion emitter points, simply rotate point cleaner knob located 6.1 Emitter Cleaning at center of each outlet clockwise to the stop (approximately one turn) and release.
  • Page 8 1. Take a piece of plastic and rub it with cloth until a static charge can be read with the static meter. 2. Turn on the E-003 unit and set fan speed to high. 3. Hold the plastic one foot away from center ionized air outlet for five seconds.

  • Page 9: Task Light Replacement

    Do not try to determine ion balance by holding a static meter in the ionized air stream. This will result in a meaningless reading. Ion output of the E-003 unit is inherently balanced by design. 6.5 Calibration As a result, there are no calibration adjustment. After checking ion balance as outlined in Section 5.4,if an unbalance or offset voltage...

Table of Contents