Page 1
J.E. ADAMS INDUSTRIES OWNERS MANUAL MODEL 9500 SERIES o PAGE 2 PRODUCT INFORMATION o PAGE 3 SPECIFICATIONS o PAGE 3 IMPORTANT SAFETY INFORMATION o PAGES 4-5 INSTALLATION o PAGES 5-6 PROGRAMMING o PAGE 6 OPERATING o PAGE 6-7 MAINTENANCE o PAGES 7-8...
There may be more than one key number depending on unit. Please keep this information with your records. MODEL#:_________________________________________ SERIAL#:_________________________________________ KEY NUMBER(S):_________________________________ DATE PURCHASED:_______________________________ DISTRIBUTOR:___________________________________ J.E. Adams Industries 1025 63 Ave. S.W. Cedar Rapids, IA 52404 1-800-553-8861 www.jeadams.com...
Installation Instructions: DANGER • Determine location to mount unit (“ ” “THIS EQUIPMENT INCORPORATES PARTS SUCH AS SWITCHES, MOTORS, OR THE LIKE THAT TEND TO PRODUCE ARCS OR SPARKS THAT CAN CAUSE AN EXPLOSION. WHEN LOCATED IN GASOLINE-DISPENSING AND SERVICE STATIONS INSTALL AND USE AT LEAST 20 FEET (6 M) HORIZONTALLY FROM THE EXTERIOR ENCLOSURE OF ANY DISPENSING PUMP AND AT LEAST 18 INCHES (450 MM) ABOVE A DRIVEWAY OR GROUND LEVEL.”...
If different acceptor was purchased, see additional literature sent along with unit for programming info. Bill acceptor: • Bill acceptor comes pre programmed from J.E. Adams and should not require any changes. If additional programming is needed to acceptors please refer to additional literature sent along with this unit. Display: •...
DISPLAY “SAVED”. THIS FUNCTION ALLOWS YOU TO MONITOR THE AMOUNT OF COINS THE MACHINE TAKES. 4) NEXT, THE TIMER WILL DISPLAY “COINS TO START”. USE THE UP AND DOWN ARROW KEYS TO CHANGE THE AMOUNT OF COINS TO START. PRESS THE SAVE KEY TO SAVE YOUR INPUT.
• Check motor brushes approx. every 3 months for excessive wear. Motor brushes should Please disconnect power be changed if they are shorter than ¼”. before doing this. • Check all shampoo lines and assembly for any signs of wear. •...
Vac motors will not shut Check contactor for vac and located in If contact is stuck open replace off after display has relay control box with new contactor. (5967D001) timed out Shampoo/spot keeps Check surface mount relay labeled If contact is stuck open replace running after display has shampoo or spot for contact stuck.