Neilsen CT3154 Instruction Manual

14 PIECE INJECTOR EXTRACTOR WITH SLIDE HAMMER
CT3154
PRODUCT USE AND CARE
This product is not a toy. Keep it out of reach of children.
Use the correct product for the correct vehicle. The correct product will do the job
better and safer at the rate for which it was designed. Do not modify this product or
use it for a purpose for which it is not intended.
Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the product's operation. If damaged, have the product
repaired before use. Use the product and accessories etc., in accordance with these
instructions and in the manner intended for the particular type of product, taking into
account the working conditions and the work to be performed. Use of the product for
operations different from those intended could result in a hazardous situation.
SAFETY INSTRUCTIONS
WARNING! Ensure Health and Safety, local authority and general workshop
practice regulations are adhered to when using tools.
WARNING! Always use caution when working around fuel systems. The fuel in the
fuel rail may be pressurised even if the engine is not running.
IMPORTANT: These instructions are provided as a guide only. Always refer to the
vehicle manufacturer's service instructions, or a proprietary manual, to establish
the current procedure and data, also any warnings or cautions particular to the
vehicle.
DO NOT use the set if any parts are missing or damaged.
DO NOT use this tool for any purpose other than that for which it is designed.
Switch off vehicle's ignition and disconnect the battery before commencing work
under the bonnet.
You must follow the vehicle's service manual cautions when working around the air
bag system. If the cautions are not followed the air bag may deploy unexpectedly
even after the ignition is turned 'OFF', resulting in personal injury.
Never lay tools on the vehicle's battery. This may short the terminals together,
causing harm to yourself, the tools, or the battery.
Operate in a well ventilated area. Do not inhale fuel vapours.
Wear approved eye protection. A full range of personal safety equipment is
available from your dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long
hair.
Keep children and other unauthorised persons away from the working area.
Keep yourself, tools, and test equipment away from hot engine parts.
Always keep a fire extinguisher close by, that is suitable for fuel/ electrical/chemical
fires.
NEVER smoke or have open flames near vehicle.
Always relieve fuel pressure before disconnecting fuel lines from injectors.
Use a rag to cover fuel line fittings, when connecting or disconnecting fuel lines.
Avoid contact with fuel.
Clean up all fuel spills immediately and dispose of all rags properly.
Maintain the tool components in good and clean condition for best and safest
performance.
When work on the vehicle is finished, ensure all connections on vehicle are
restored, and that there are no tools left in the engine bay.
Replace tools in the carrying case and store in a safe, dry, childproof location.