Page 1
TC-RAIL28-EX12 28” Rail System Installation guide for EX1M4 and EX2M8 Rackmount Chassis Maximum Mounting Distance: The maximum mounting distance is 32.5” with 3 screws installed onto the front and rear L-shaped brackets The maximum mounting distance can be 35.75” with 2 screws installed onto the front and rear L-shaped brackets. Not recommended...
Page 2
Minimum Mounting Distance: The minimal mounting distance is 29”. See last page for more details The minimal mounting distance can be 27.5” when only using 2 screws to secure the rear L bracket. Not recommended.
Page 3
Installation Guide: 1. Install and secure inner rails to chassis with two screws on each side 2. Install outer rails to cabinet/rack. Adjust the front L bracket as forward as possible to maximum distance first, then adjust the rear L bracket to fit the cabinet/rack.
Page 4
3. Mount chassis onto cabinet/rack. Before sliding in chassis, make sure rails are all the way to the front. Pull latches forward (toward you) on both sides of chassis to slide in chassis. Push latches backward to release chassis from rails.
Page 5
4. Secure chassis to cabinet via thumb screws when needed...
Page 6
If cabinet mounting posts distance is 29” or under, ensure the spacing between front L bracket and rackmount flange is no bigger than 1/8” (can be zero), otherwise chassis cannot be secured to cabinet’s mounting posts. See below image If the spacing is bigger than 1/8”, chassis cannot be secured to cabinet due to too much spacing between front L bracket and rackmount flange.
Need help?
Do you have a question about the TC-RAIL28-EX12 and is the answer not in the manual?
Questions and answers