Page 1
HO523 WIFI INSTALLATION Follow the steps below to install the WS103 WiFi/Bluetooth module on the HO523. Step 1 Remove the screws from each side of the HO523 (four screws total). Step 2 Using your thumbs, slide the top casing towards the back. Then, remove it...
Page 2
Step 3 Insert the WS103 module into the M.2 connector at an angle of approximately 20 degrees. Step 4 Secure the WS103 using the screw included with the module.
Page 3
Step 5 Remove the rubber cap from the antenna port near the WS103 module (i.e. the port on the left side of the front panel). Step 6 Insert the threaded antenna connector into the antenna port.
Page 4
Step 7 Secure the threaded antenna connector using the washer and nut included with the module. Step 8 Tuck the excess antenna cable into the space between the circuit board and the bottom casing.
Page 5
Step 9 Replace the top casing on the player, making sure it locks fully into place. Step 10 Reinsert and secure the screws on each side of the HO523.
Page 6
Step 11 Attach the antenna to the threaded antenna connector.