Advertisement
Program Functions On The GENII CS Rem
Start Programming Mode
To enter Programming Mode depress and hold the
OFF
buttons for 5 seconds. The display will become blank
ON
indicating that you are in the Programming Mode. Release both
keys and the display will show parameter 0.
Whilst in the programming mode the following buttons are
active:
OFF
Change to the next parameter.
ON
Increase the current parameters value.
Decrease the current parameters value.
Parameter 0: Rem Address
The display will show current REM Address of the device.
• The range of address is 0 to 15
• The default address is 0
Parameter 1: Maximum Input Value
The display will show the Maximum Input Value to which the
module's input can be set.
• The range of Maximum Input Value is 0.0 to 99.9
• The factory default setting is 30.0
Parameter 2: Minimum Input Value
The display will show the Minimum Input Value to which the
module's input can be set.
• The range of Minimum Input Value is 0.0 to 99.9
• The factory default setting is 15
Exit Programming Mode
To exit the Programming Mode depress the
buttons and the new setting will be saved.
Start Up Default Settings
The GENII CS REM Module can be set to start in any mode of
operation.
1. To set the start up default adjust the GENII CS REM Module
to the desired settings and then press and hold the
and
buttons for 5 seconds.
2. The display will become blank indicating that the new
settings are saved.
Operating Functions On The GENII CS Rem
Numerical Output
and
The GENII CS REM Module will display a 3 digit, single decimal place
analogue output value during normal operation.
Numerical Input
The GENII CS REM Module will provide a 3 digit, single decimal place
analogue input value to the GENESIS Controller during normal
operation.
This value can be modified by pressing the
0.1 or the
Digital Input Toggle Value
The
OFF
ON
value to the GENESIS Controller during normal operation.
This operates as a standard toggle switch, i.e. Press the
once to change the state of the digital input. The state of the digital
input value can also be changed by the Timer on the GENII CS REM
Module.
Digital Output Led
The GENII CS REM displays a digital state via the system LED during
normal operation.
Timer Operation
The Timer on the GENII CS REM Module allows for automatic toggling of
the digital input value.
Pressing the
10 minutes to 24 hours. Successive pressing of the
increment the timer value until it reaches 24 hours, in which case it then
resets to the value of 10 minutes.
OFF
and
The timer LED indicates that the timer is active. When the timer value is
ON
reached the GENII CS REM Module will automatically toggle the digital
input value. This has the same effect as the
manually
OFF
ON
© MASS ELECTRONICS Pty Ltd 2006
DS 15.08 - GENII CS REM - Control Station Module
button to decrement by 0.1.
button on the GENII CS REM Module provides a digital input
button allows the timer to be set at a value from
Page 3
August 2013
button to increment by
OFF
button
ON
button will
OFF
button being pressed
ON
Advertisement
