This Nitrous Outlet Switch Panel is designed specifically for the 2015+ Dodge Challenger. If you need any assistance during installation or if
you have questions about this wiring harness, call our Tech Help Line at (254) 848-4300.
Tools Needed for Installation*:
• Phillips Head Screwdriver
• Ratchet
*These are the tools required for installation of this kit on a stock vehicle. If your vehicle has aftermarket parts, other tools may be required.
IMPORTANT- ALL APPROPRIATE SAFETY EQUIPMENT (GLOVES, TOOLS ETC.) MUST BE USED DURING THE INSTALLATION OF THIS PRODUCT(S). NITRO DAVE'S LLC ACCEPTS NO
RESPONSIBILITY FOR INJURIES RESULTING IN THE INSTALLATION OF ANY PRODUCT(S). NITROUS OXIDE IS FOR OFF-ROAD USE ONLY.
W W W . N I T R O U S O U T L E T . C O M / I N S T A L L A T I O N - G U I D E S
N I T R O U S O U T L E T | 3 0 5 S O U T H 2 8 T H S T R E E T | W A C O , T X 7 6 7 1 0 |
2015+ Dodge Challenger Switch Panel Installation
PART NUMBER: 00-11045
I N S T A L L A T I O N I N S T R U C T I O N S
I N S T A L L A T I O N I N S T R U C T I O N S
• Flat Head Screwdriver
• 7mm Socket
• Plastic Trim Tool
Step 1:
Make sure the car is in neutral and the emergency brake is
engaged and/or blocks in front and behind the tires to keep
the car from moving.
Step 2:
Using a plastic pry tool, carefully pry the leather boot up while
pulling with your hand on the inside. There are 6 clips hold-
ing it in place and lift up easily.
P : 2 5 4 - 8 4 8 - 4 3 0 0 | W W W. N I T R O U S O U T L E T. C O M
• 10mm and 13mm Socket
• Short Extension