Wechsel NUBO User Manual page 2

NUBO
USER'S GUIDE
Thank you for choosing a Wechsel sleeping pad. Please read these instructions thoroughly before you use the pad for the first
time. Please follow these instructions closely when using your new pad, to avoid any damages. Please keep this instruction
manual for further reference.
USAGE
The mat has an inlet and an outlet valve.
The inlet valve is located on the pump unit at the head section
of the mattress. This "pump" consists of a foam core, that is
still very compressed when used for the first time. Therefore
the inflation may take a little longer. The pump can be oper-
ated by hand or foot. ATTENTION. The valve should always
face to the top while inflating.
To speed up the inflation of the mattress, you may use the
outlet valve to inflate the mattress, e.g. using a separately
sold pump.
CAUTION! The mat is not suitable as a swim toy.
CLEANING
ATTENTION. This sleeping pad is not machine washable!
Please always clean it by hand. Please use only warm water
and a sponge or soft brush to clean the surface of your
mattress. Optionally you can use a residue-free detergent
to clean it.
The mat should be stored with the valves open. Only
store when completely dry.
WECHSEL
Skanfriends GmbH
Feurigstraße 54
10827 Berlin, Germany
Tel: (+49) (0)30 39034010
Fax: (+49) (0)30 39034012
www.wechsel-tents.com
info@wechsel-tents.com
REPAIR
1. To repair smaller leaks, holes, tears, or punctures in your
sleeping pad, first mark them with a pencil. If the holes
are too small to be visible to the naked eye, you can easily
find them by holding the mattress under water.
2. Please clean the leaking area. Only use a soft cloth and a
mild detergent. Please let the cleaned area dry thoroughly
before continuing.
3. Deflate the pad completely and close the valve.
4. The patch should be approx. 1 cm larger than the hole you
want to repair. Please round off the edges of the patch.
5. Apply the glue to the area of the leaking, press the patch
firmly onto the glue, and hold it down for 2-3 minutes.
Please extend the glue beyond the size of the patch you
are going to use. This way the adhesive should get a good
hold.
6. Please let the repaired mattress dry overnight.