Operational Use ......................... 10 Troubleshooting Guide ..................... 10 Maintenance ........................11 Occupational Health and Safety ..................11 Transport and Storage ...................... 11 Terms of warranty ......................12 Sample of the Declaration of Conformity ................ 15 804K08 KOS-AL 30.01.2019/EN extraction rail ERGO-KOS-AL 30.01.2019...
Risk assessment and risk reduction” 2. Application ERGO-KOS-AL is designed for extraction of welding fumes at mobile workplaces – for linear wel- ding of elements of length up to several metres. The system can work with one or two extraction fans, depending on the quantity of extraction arms (one extraction arm is subordinated to one fan).
Page 3
3 metres. for wall installing 804K27 Terminal stopper Nr kat. Uwagi Serves to stop the suction trolley 804K30 at the end of the duct. Duct segment joint Type Part. No 804K21 extraction rail ERGO-KOS-AL 30.01.2019...
The suction hood ought to be adjusted at a distance at least ca. 30 cm from the wel- ding point. Fig. No.1 – ERGO-KOS-AL rail system for contamination extraction 6. Assembly and Start-up All the constructional elements of the KOS-AL duct are listed in Table No.1 “Technical Data”.
Page 5
M6 bolts (6 pieces) to the trolley flange. NOTE: The extraction arms themselves ought to be assembled according to their manual / assembly instruction for extraction arms. Extraction arms are delivered in a partly assembled state. Fig. No 3 extraction rail ERGO-KOS-AL 30.01.2019...
Page 6
– connecting the fan with the air discharge outlet. In order to select the fan, carry out the flow resistance calculation for all the elements of the designed installation. Flow charts of the extraction arms: Fig. No.4 extraction rail ERGO-KOS-AL 30.01.2019...
Page 8
– on wall brackets. Selection of a fan: For applications with an indoor fan we suggest using the fan WPA-E-N series of fans of KLIMAWENT S.A. production. Fig. No.7 – WPA-E-N – Flow charts extraction rail ERGO-KOS-AL 30.01.2019...
Page 9
3 x 400 99/90* 85/76* 10800 3300 a/ For applications with a fan located on the roof we suggest using the fan WPA-D-N series of fans of KLI-MAWENT S.A. production. Fig. No.8 – WPA-D-N – Flow charts extraction rail ERGO-KOS-AL 30.01.2019...
Suddenly occurring vibra- Foreign matter / object got stuck Disconnect the motor and tions of the fan within the impeller remove the object Impeller failure Replace the impeller for a new extraction rail ERGO-KOS-AL 30.01.2019...
The transport / reloading ought to eliminate the hazard of damage, scratching, indents of the elements of the system. Pay attention that the packages would not get damaged, and the markings on the surface would not get obliterated or detached. extraction rail ERGO-KOS-AL 30.01.2019...
Infringement of the Section 3 “Reservations of Producer” of the present Use and Maintenance Manual and especially modifications undertaken by User on one’s own or use in contra- diction with the purpose of application – shall result in the loss of warranty validity. extraction rail ERGO-KOS-AL 30.01.2019...