Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Green-Go Bridge X
- Page 1 Bridge X Quick Start Guide...
- Page 2 Quick Start Guide The Green-GO Bridge X enables you to connect your local Green-GO network to an external Green-GO Device or network anywhere in the world. It is able to route up to 4 Users or Groups to a remote location.
-
Page 3: Setup Menu Navigation
Setup menu navigation Pressing the encoder will open the setup menu of the Green-GO Bridge X. Once in the menu, the encoder will allow you to navigate through the menu and set a parameter. Pushing the encoder will confirm your selection. - Page 4 Set up a group bridge To set up a Group bridge you will need a Green-GO bridge on both Green-GO networks.Setting up a group bridge is explained below. A Bridge connection needs 2 sides; A Passive side that listens on a UDP port to an incoming connection, and an Active side that connects to a port on a remote IP.
- Page 5 à Discard all changes made on this port connection Set up User Access To Set up remote User access, you need a Green-GO bridge on the local Green-GO side of the connection The other side can either be a green-GO device, a green-GO bridge or an I-phone running the Green-GO app.
- Page 6 Cancel à Discard all changes made on this port connection Configuration cloning All devices in the local Green-GO network need to have the same configuration to be able to communicate with each other. Clone Config à Clone a configuration file from the network Configuration File A à...
- Page 7 4 hours. Display à Set the Intensity of the display. Device information Info à Shows general information about the Bridge X Config : à The current config of the Bridge X SN: xxx à Serial number of the Bridge X BridgeX 4a61 à...
-
Page 8: Technical Specifications
In all of the previous conditions, disconnect the main plug immediately and call your distributor or technical support! WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE __________________________________________________________________________________ Green-GO Bridge X – Quick Start Guide... - Page 9 All signal input- and output connections must be shielded and the shielding must be connected to the ground of the corresponding plug. Gemert, November 20, 2018 ing. Joost van Eenbergen __________________________________________________________________________________ Green-GO Bridge X – Quick Start Guide...
Need help?
Do you have a question about the Bridge X and is the answer not in the manual?
Questions and answers