Pioneer S-DW1-K Operating Instructions Manual page 5

CONNECTION
Connection with a normal audio system
Connect the speaker output terminal
of
your amplifier or
receiver
with two parallel-wire
cords.
NOTES:
.
Connect the
amplifier (or receiver) and
the S-DWI
-K
and the speaker
systems so that the
polarities
(L &
R, @
A
O) between
them are correctly
connected.
.
When operating near
your
speaker system, feedback
may occur when the power supply
of the amplifier (receiver) or
the
speaker switch is turned OFE
or
if
the subwoofer level
is
set
too high.
Beware of the following, as
the subwoofer
may
be damaged
by
feedback:
1. lf
possible, connect
the
power cord of
the
S-DWI-K to
the
switched outlet of
the amplifier.
2. ln
the case of amplifiers or receivers without a
switched outlet, be sure to decrease the level of
the subwoofer before
turning
the
power supply of
the amplifier or the speaker switch OFE
.
A buzzing noise may occur
when the speaker switch of
the
amplifier or receiver is turned off or
the
power supply is discon-
nected and
the subwoofer level
is
set too
high.
This is
not a failure, so once more connect
the
power
supply
to
the receiver and
turn the speaker switch on
to
remove
the
noise. Lower
the
subwoofer level
when the subwoofer
is not
in
use.
CONNECTION
1
1. Connect the amplifier or
receiver speaker output
terminals
to
the S-DW1-K HIGH LEVEL ]NPUT ter-
minals with the
two parallel-wire cords of the audio
system.
2.
Connect the S-DW1-K HIGH LEVEL OUTPUT ter-
minals to the speaker system, using the two paral-
lel-wire cords.
NOTE:
Use
speakers
with
a rated impedance
which corresponds with
the
indicated impedance at
the rear
panel
of the
amplifier or
receiver.
Speaker system
5
k,