Advertisement
Notice:
Loosen the two screws in the seat cover position of vehicle body. Unplug the
wire connector from the gear box connector, take out motor and charger.
When in assembling any wheel to the axles,we provide two gaskets. Please
decide whether to increase gaskets to adjust tightness degree of the wheels
free to turn. Motor should be assembled as the mark on the car body prompts
Picture-1
Picture-3
Motor
Wheel
On the left after
turning over the car
Bushing
Nut
Hubcap
Decoration
Wheel
Hubcap
Washer
Picture-2
On the right after
turning over the car
Bushing
Nut
Hubcap
Decoration
Hubcap
Washer
Assembly Steps
Driving Connection Assembly
Turn the vehicle body over
Insert direction lever into the white
hole in the gear motor.(P-2) Make
the directionlever pass through the
instrument panel. Direction lever must
be inserted into the hole.(P-3)
The hole on the directionlever should
be inserted into the hole of the motor
then use M4*22 round screws fix the
gear motor tightenly.(P-1)
Driving Wheel Assembly
Inserting rear axle from the right side to
the left side, assembling spare parts
according to the picture at left.
Bushing
Motor
Washer
Nut
Hubcap
If two motors, the assembly way is the
same
(If single motor, assembling on the left side which is
marked "L", if two motors, the marks "L" and "R" on
the motor and car body should be corresponding)
(Be sure that bushing is put into the wheel completely)
Another Rear Wheel Assembly
Assembling accroding to the picture at left.
Bushing
Washer
Washer
Nut
Hubcap Decoration
Hubcap
Bushing
Wheel
Hubcap Decoration
Wheel
Bushing
Advertisement
