Advertisement
Quick Links
Advertisement
Summary of Contents for BRITBE G3 PRO
- Page 1 G3 PRO 2018 Britbe Detectors Locator Detector Instruction Manual Buried Treasure Detector...
- Page 2 G3 Pro DISCRIMINATION ● IRON ● COPPER ● SILVER ● GOLD With the function of the discriminator, you can select the of metal you want to detect. Place the batteries in the marked place (BATTERY). Connect the wire correctly to the antenna grip and the other end to the equipment.
- Page 3 G3 PRO IONIC SENSOR The ionic system can detect the ions produced by the noble metals gold and silver. The detection by this system is done by turning on the radar system and increasing the sensitivity to a very sensitive point, This detection system is effective in dry soils (non-humid) where the metals react with the temperature of the sun and emit the ions detected by the equipment.
- Page 4 G3 PRO BATTERY OF LOCATOR -The control box works with a 9-volt battery, which is located in the lower part of the control box. -Lift the lid and pull out the connector cable from the battery, place the battery and close the lid.
- Page 5 Turn on the locator antenna with the switch, in case it does not turn on, press the red button on the side. When the antenna is turned on, it will start working, tracking the signals of the selected metal type in the control box. To perform the detection with the antenna, keep the RADAR turned off (OFF) R ADAR SYSTEM OR IONIC ...
- Page 6 G3 PRO Performance Demonstration Metals you will need to perform the test practices 1 - an object of iron, aluminum, copper, silver, gold. Bury each of these metals in different places at a maximum depth, keep in mind that this equipment can detect up to 25 meters deep...
- Page 7 G3 PRO RECOMMENDED SEARCH SYSTEM DETECTION BY CROSSING (X) It is important to carry out the prospection using the cardinal points Carry out the north-south or east-west direction tracing to obtain an approximation of the center, in this way it will facilitate the location of the detected point, after locating the point, perform the depth measurement.
- Page 8 G3 PRO SEARCH SYSTEM The antenna is always oriented to the detected metal The treasure or buried object produces a magnetic field, the magnetic field emits a signal that captures the locating equipment through the receiving antenna TEST TO PROVE DEPTH The buried metal object produces magnetic radiation.
- Page 9 The detector equipment is prepared to calibrate the frequencies of each type of metal you want to detect. The G3 PRO receives the signal of the detected metal that is selected, the antenna tells you the direction where the buried metal is located, what the operator does is to walk in the direction indicated by the antenna.
Need help?
Do you have a question about the G3 PRO and is the answer not in the manual?
Questions and answers