Table of Contents
Advertisement
Face Detection
Under Temperature Measurement, navigate to Parameter Configure.
1.
2.
Enable Face Detection and Show Detection Area.
3.
Area ID is the number of detection areas. Generally, we only need to set one detection area but
we can optionally set up to 8. For each area, click points on the image to draw a frame over the
target observation area.
4.
Face Pixel Min, Face Pixel Max and Image Matting Quality refer to the quality of the face image that
is saved after it is detected. All three can be adjusted according to your systems requirements.
5.
Leave other options at their default values.
6.
Refer to the User Manual for more detailed information on each configuration setting.
Click Apply to save settings.
7.
Temperature Parameters
Set Enable to On to enable temperature detection.
1.
Swap between Celcius and Fahrenheight under Temperate Unit. Celsius is set as default.
2.
3.
Set the Ambient Temperature to the temperature of the camera's environment; e.g. indoor
temperature of 25 °C.
8
DCS-9500T Quick Installation Guide
Advertisement
Table of Contents
