Safety Information IMPORTANT SAFETY INSTRUCTIONS – DO NOT DESTROY! WARNING: Failure to follow these safety instructions may lead to personal injury, including burns! WARNING: TO REDUCE THE RISK OF BURNS, FIRE OR ELECTRICAL SHOCK, READ AND FOLLOW THE BELOW INSTRUCTIONS CAREFULLY BEFORE USING THIS THROW! DO NOT USE THIS THROW: •...
Page 4
Safety Information • Product not for use with inverter supplied power such as from a motor home or boat. • This product is for in-home use only; not for hotel, motel, or other institutional use. • If improper operation of this throw is observed, discontinue use immediately and consult the manufacturer.
Features Your heated throw has a built-in feature called “Auto-Off”. This feature will automatically turn off Auto Off the controller after 10 hours of continuous use. Our heating and sensing wire is designed to Thin & be thin and flexible in order to provide a higher Flexible Wires comfort level.
Getting Started - Throw Step 1: Step 3: Remove the heated throw from Securely attach the connector cord the package along with the from the controller to the connector on controller. the heated throw. Make sure that the connection is firmly secured. Step 2: Step 4: Lay the heated throw out flat,...
Instructions 1. Turning “ON” Turn the controller ON manually by pressing the ON / OFF button or switch. Turn the dial and the analog style controller will backlight the heat level setting on its dial. If the backlight does not illuminate, see the FAQ section.
Washing Instructions CAUTION! Do not iron your throw. WARNING: Failure to follow these washing CAUTION! Do not dry-clean this instructions may damage the product. Cleaning solvents may have a product and make it unsafe. deteriorating effect on the insulation Wash by hand or as follows in an of the heating element.
Frequently Asked Questions Place your hand inside the folds. If you do feel heat during this test, the prod- uct is working properly. Turn the controller OFF. Lay the product out flat. It is safe to resume normal operation after 20 minutes. If no heat is felt during this test, unplug the power cord and contact Customer Support.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interfer- ence that may cause undesired operation. Changes or modifications to the product are not approved by Biddeford Blankets and could void the user's authority to operate the equipment under FCC jurisdiction.
Need help?
Do you have a question about the 57106 and is the answer not in the manual?
Questions and answers