Advertisement
Advertisement
Table of Contents
Summary of Contents for Valley Dynamo Hockey
-
Page 2: Warranty Length
DEALERS AND DISTRIBUTORS – To obtain replacement and an RMA number, contact Valley-Dynamo referencing the Model number and Serial number of the unit and the nature of the problem. Valley-Dynamo will, at its discretion, send replacement parts and/or issue an RMA for... - Page 3 To avoid billing issues, request an RMA when the failed part is present or readily available. Credit will be issued only upon receipt and inspection of the RMA. Valley-Dynamo may send replacement parts or issue an account credit. NO REFUNDS. Valley- Dynamo reserves the right to cancel outstanding RMAs 30 days after issue.
-
Page 4: Exclusion Of Damages
Valley-Dynamo’s sole obligation and liability under this warranty is limited to the repair or replacement of a defective product at our option. Valley-Dynamo shall not, in any event, be liable for any incidental or consequential damages resulting from interruption of service, loss of business or revenue, or for liability in tort relating to this product or resulting from its use or possession. - Page 5 USE OF NON-DYNAMO PARTS OR CIRCUIT MODIFICATIONS MAY CAUSE SERIOUS INJURY OR EQUIPMENT DAMAGE! USE ONLY GENUINE DYNAMO AUTHORIZED PARTS. For safety and reliability, substitute parts and modifications are not recommended. Substitute parts or modifications may void FCC type acceptance. ...
- Page 6 Before proceeding, we recommend having these tools: Socket Wrench with a 7/16” Socket Phillips Screwdriver Pliers – regular or needle-nose (preferably one of each) 1/8” Allen hex key wrench Your overhead box should contain these hardware items ...
- Page 7 BE SAFE: We recommended that you have at least two people involved in the setup of this overhead. Seriously. BE PREPARED: Contact your Distributor immediately if any parts listed on the prior page are missing from your overhead or your bulbs arrived broken 1.
- Page 8 9. Slip one ¼” flat washer over each stud, and thread a ¼” – 20 kep nut onto each stud. Tighten the nuts by hand to secure the housing, then secure them in an alternating “X” pattern using the 7/16” socket (you will fully tighten them later, but this is to keep the housing in place during mounting).
- Page 9 18. Now with the male and female overhead tubes both mounted into the side bracket clamps, tighten all mounting brackets and clamps until securely fastened. 19. Use the last ¼”-20 hex head bolt and washer to secure the female overhead tube (front side of table) to the mounting bracket clamp and SECURE BOTH SIDES FIRMLY with your 7/16”...
- Page 10 the tube snap into place. Check to make sure both ends of the tube are secured before releasing the bulb. Repeat process for second bulb. 25. Apply power to the table. Both bulbs should light up immediately. If either or both bulbs to not illuminate, check to make sure they have a good connection to the sockets as described in the previous step.
Need help?
Do you have a question about the Dynamo Hockey and is the answer not in the manual?
Questions and answers