1. Manuals
  2. Brands
  3. novotechnik Manuals
  4. Monitor
  5. MAP 4000 Series
  6. Setup manual

novotechnik MAP4000 Setup Manual

Hide thumbs Also See for MAP4000:
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual

1) Connections to the MAP4000

a. Connect the Potentiometer to the MAP4000 process monitor.
a.i. Connect PIN 1 of the POT to PIN 23 on the MAP
a.ii. Connect PIN 2 of the POT to PIN 22 on the MAP
a.iii. Connect PIN 3 on the POT to PIN 20 on the MAP
b. Connect power cord to MAP4000
b.i. Connect BLUE to PIN 1
b.ii. Connect BROWN to PIN 2
b.iii. Connect GREEN to PIN 3

2) Input button definitions:

a. HOME key = The left most key on the MAP4000 process monitor.
b. LEFT ARROW key = The left arrow key on the MAP4000 process monitor.
c. DOWN ARROW key = The down arrow key on the MAP4000 process monitor.
d. UP ARROW key = The up arrow key on the MAP4000 process monitor.
e. ENTER key = The right most key on the MAP4000 process monitor.

3) Select Potentiometer TYPE on MAP4000

a. Hold down the HOME key and ENTER key together to enter programing mode.
a.i. PASSW then TYPE will be displayed
a.ii. Press the ENTER key again to select type of input you want for this device. In
this case we want to select DU (for potentiometers). If DU is not flashing on the
screen at this point in the process, use the UP ARROW or DOWN ARROW keys
until DU is displayed.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAP4000 and is the answer not in the manual?

Questions and answers

Related Manuals for novotechnik MAP4000

Summary of Contents for novotechnik MAP4000

  • Page 1 HOME key = The left most key on the MAP4000 process monitor. b. LEFT ARROW key = The left arrow key on the MAP4000 process monitor. c. DOWN ARROW key = The down arrow key on the MAP4000 process monitor.
  • Page 2 Use the UP ARROW key to display MIN A and then press the ENTER key. b.i. You can set this value to what you want the MAP4000 to display in your first calibration position. In this case we will set it to 0.
  • Page 3 You can set this value to what you want the MAP4000 to display in your end calibration position. In this example we will set it to 180. c.ii. You can adjust this value to whatever you would like by pressing and/or hold down the UP ARROW or DOWN ARROW keys.
  • Page 4 ARROW key to be the CLEAR TARE. b. Program and define TARE key: b.i. The first step is to get into the Profi menu on the MAP4000. This is done by pressing the HOME key and the DOWN ARROW key at the same time. “INPUTS”...
  • Page 5 Press the HOME key to get out of the menu mode. The DOWN ARROW key is now defined as a CLEAR TARE key. Test this by pressing the DOWN ARROW key. The MAP4000 should now display the original set up points from step 6 above.

Table of Contents