Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ross RPPW2600
Summary of Contents for Ross RPPW2600
- Page 1 Protect yourself and others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property. Please retain instructions for future reference! ROSSPOWER RPPW2600...
- Page 2 RPPW2600 2600 psi (180 bar) 2000 psi (140 bar) 8 L/min 5.5 hp 163cc...
- Page 10 Assemble the hose support(A) to the right side Assemble the stainless steel wand (A)and the metal gun(B). Pull back the rubber piece(C) to of the frame using 2 pan head bolts, 4 washers expose the threaded fitting and screw the 2 and 2 nylon hex nuts.
- Page 11 PRE-START CHECK OIL LEVEL WARNING! Pressure washer has no oil currently in crankcase! Operating the unit without the correct amount of oil will damage the engine. Oil crankcase capacity: 0.6 L. Always check the oil level before starting the engine, make sure the pressure washer is on a level surface before checking oil level.
-
Page 12: Start-Up Procedures
PRE-START CHECK AIR FILTER WARNING! The air filter should be checked after prolonged storage, the following steps should be done when checking the air filter. It is recommended to replace the air filter once every Spring. 1) Snap the top and bottom clips(A) backwards and remove the air filter cover(B). -
Page 13: Nozzle Usage
OPERATION: SPRAY NOZZLE USAGE This pressure washer comes with a stainless steel wand, its tip has a quick connect coupler to fit different nozzles. The spray pattern is adjusted by installing the appropriate spray pattern nozzle to the quick connect coupler. Five nozzles are included, 0°, 15°, 25°, 40°... -
Page 14: Using The Pressure Washer To Clean
HOW TO USE DETERGENT WITH PRESSURE WASHER: 1) Ensure detergent siphon tubes are set up correctly. You may want to refer to assembly instruction #8 on page 10 to verify that siphon tubes are set up properly. 2) Pour the two kinds of detergents into the detergent tanks. It is recommend to have one detergent tank filled with All-Purpose detergent, and the other filled with a more specific cleaning detergent. - Page 15 7528%/(6+227,1* 352%/(0 &$86( &255(&7,21 Engine will not start (or stops 1. Low-oil shutdown 1. Fill engine with SAE 10W-30 oil while operating) 2. Engine switch not in “ON” 2. Turn switch “ON” position. 3. Squeeze trigger while starting 3. Pressure built up in the hose If engine sounds abnormally, it 1.
-
Page 16: Maintenance
MAINTENANCE This pressure washer is equipped with a water inlet filter. This water filter must be kept clean at all times or else it will restrict the water flow to the pressure washer and may damage the pump. Remove the quick connect coupling from the water inlet, then remove and clean water filter. -
Page 17: Pressure Washer Storage
4) Reinstall spark plug in the reverse order. PRESSURE WASHER STORAGE: -If you plan on storing your pressure washer for an extended period of time, the following steps should be followed: 1) Add fuel stabilizer to fuel tank to minimize the formation of fuel gum deposits during storage. 2) Run engine at least 5 minutes after adding stabilizer to allow it to enter the fuel system. - Page 18 ',$*5$0 $1' 3$576 /,67 18 | P a g e...
- Page 19 5HI 1R '(6&5,37,21 47< 5HI 1R '(6&5,37,21 47< Wand Inlet quick connector Drain pipe Bolt M5*45 Circlip Washer 5 Washer 16 Bolt M5*40 10" (25.4 cm) wheel Nozzle Wheel shaft 0° nozzle (red) Spring gasket 8 15° nozzle (yellow) Inner hex bolt M8*25 25°...
-
Page 20: Warranty
Should service become necessary during the warranty period, the purchaser should contact an Authorised Service Centre or J W Ross. In order to obtain warranty service, the purchaser must present the store receipt showing the name of the retailer and the date of purchase.
Need help?
Do you have a question about the RPPW2600 and is the answer not in the manual?
Questions and answers