CAMDEN Aura CM-55i Installation Instructions

D o o r Ac t iv a ti o n D e v i c e s
Aura™ CM-55i
Flush Mount Illuminated Enclosure
INSTALLATION INSTRUCTIONS
THIS PACKAGE INCLUDES:
1- CM-55i 1- Red / Green / Blue Aura PCB
2- Dry Wall Bracket 2- 8-32 x 1-1/2" Screws
1. GENERAL DESCRIPTION
Camden Aura™, Model CM-55i provide the Industry's 1st
"Changing State" illuminated switch enclosures.
They offer field selectable red/green/blue illumination,
activated directly by the switch or remotely by a relay* such as
our CX-33 or EMF-2, a time-clock or access control system.
User selectable features include a 3 Amp Form C relay, and
piezo speaker for audible annunciation, as well as control
over the idle and active LED colours. Another exclusive is the
ability to plug in a TX-9 RF transmitter, thereby requiring only 2
conductors be run for power (no batteries required).
The box is made of impact and flame resistant black ABS, and
compatible with any Camden CM-41, CM-45, or CM-46 series
switch. The illumination is provided by an array of super-bright
and energy efficient LED's, which can be powered by 12 or 24
volts AC/DC.
2. SPECIFICATIONS
Input Voltage 12 or 24V AC/DC
Output Voltage 3 Volts DC for TX-9 (only)
Current draw 250 mA @ 12VDC / 110 mA @ 24 VDC
Contact Rating 3A @ 30 VDC
Lumina Red 14.8 lumens, 1600 mW
Lumina Green 3.8 lumens, 330 mW
Sounder 3200 ± 300 Hz @ 85 dB
Relay Contact 1 x Form C
Mounting 4 x #12 wood screws with anchors
Flame-resistant black ABS
Construction
(Insert–translucent ABS)
Finish Attractive pebble finish
6-1/2" H x 6-1/2" W x 2" D
Dimensions
(165mm x 165mm x 51mm)
3. SETUP
Switch SW1 contains a bank of 3 dipswitches.
2- #6 x 3/8" Screws
Dipswitch # 3 turns the speaker on or off. Dipswitch # 2 toggles
operation of the relay, and # 1 allows you to choose whether
the color will be changed locally via the push switch or remotely.
* NOTE: The CX-12 Plus Multi-Function Relay may be used
with the Aura™, however an isolating relay must be wired in
parallel with the lock, and the relay's dry contact output wired
into the CM-55i.
Switch
SW1
Color selection is made with Switches SW2 and SW3. SW2
determines the Active color and SW3 determines the Idle color.
Setting the IDLE Color (SW2)
Switch
SW2
Setting the Active Color (SW3)
Switch
SW3
NOTE: If all DIP switches are in the OFF position, there will
be no color illuminated. This allows for no Idle color or no
Active color.
Once all DIP switches are set, proceed to Section 4 – Installation.
Position Description
REMOTE / LOCAL On to enable
1 LED color change from idle to Active
with press of the push button.
RELAY On to enable operation of the
2
relay with activation of the push button.
SPEAKER On to enable operation of
3 the speaker with activation of the
push button.
Position Description
1 ON = Red LED when IDLE
2 ON = Green LED when IDLE
3 ON = Blue LED when IDLE
Position Description
1 ON = Red LED when Active
2 ON = Green LED when Active
3 ON = Blue LED when Active
Page 1 of 5