Table of Contents
Advertisement
Lighting and visibility
Headlamp
adjustment
To avoid causing a nuisance to other road
users, the height of the halogen headlamps
should be adjusted according to the load in the
vehicle.
0. Driver only or driver + 1 front passenger.
1 or 2.
4 people (including the driver).
3. 4 people (including the driver) + maximum
authorised load.
4. Driver + maximum authorised load.
The initial setting is position "0".
56
Wiper control
The wipers are controlled directly by the driver
by means of the stalk A and its ring B.
In wintry conditions, remove snow, ice
or frost present on the windscreen,
around the wiper arms and blades and
the windscreen seal, before operating
the wipers.
Do not operate the wipers on a dry
windscreen. Under extremely hot or
cold conditions, ensure that the wiper
blades are not stuck to the windscreen
before operating the wipers.
Windscreen wipers
A. Wiping speed selection stalk: raise or lower
the stalk to the desired position.
Single wipe.
Park.
Intermittent (the speed can be set
manually),
Slow.
Fast.
B. Intermittent operation adjustment ring.
F Turn this ring to increase or reduce the
wiping frequency in intermittent mode.
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen wipers,
operate for a pre-determined time.
Advertisement
Table of Contents
