Table of Contents
Advertisement
6.7
OPERATING
SIDE SHIFT (BHES AND
1
When operating
backhoe you must be in the
with the seat belt on. Do not
from the ground beside it.
2
Ensure all
other machinery are well
and slide radius when
operating the unit
3
When operating
the relevant models ensure
fully, the dipper arm is fully
is fully crowded back. It is
swing the boom around
the opposite direction to the
This takes the load off the
and will allow it to slide
the boom in the same
about to slide it, the loading
hitch plate with catch and dig in when you attempt to slide it across, this will eventually wear out the slides or create holes
for the slide plate to catch in..
4
The stabilizer legs are to be on the ground at all times when operating the backhoe.
5
Before digging with the slide models ensure the hydraulic locks are engaged and locked into place. Do not attempt
to slide the frame with the locks engaged
6
Ensure the boom and slew safely pins are removed before use and are reinstalled after use.
Observe the following safety warnings when working with your new backhoe / tractor.
CAUTION
: Boom Carrier must be locked prior to operation.
CAUTION
: When using a backhoe, be aware of bucket and boom location at all times. When raising Boom And
Deeper Arm, material can spill onto non-target arrest causing injury or damage.
[21]
HYDRAULIC
BHUS MODELS)
any service on the
operator's seat,
operate the unit
bystanders and
clear of the swing
testing and
the side shift on
the boom is lifted
in and the bucket
also a good idea to
10-15 Degrees in
slide movement.
boom hitch plate
freely. If you slew
direction you are
edge of the boom
Hide quick links:
Advertisement
Table of Contents
