Download Print this page
Tripp Lite DataShield 93-0163 Installation Manual
Tripp Lite DataShield 93-0163 Installation Manual

Tripp Lite DataShield 93-0163 Installation Manual

Data and communication line surge suppressor

Advertisement

Quick Links

LIFETIME LIMITED WARRANTY.
Seller warrants this product, if used in accordance with all applicable
instructions, tobe
free
from original defects
in
material and workmanship
for
its
lifetime. If the product should prove defective in material or
workmanship within that period, Seller will repair or replace the product,
inits sole discretion. Service under this Warranty, can only be obtained by
your delivering or shipping the product (with
all
shipping or delivery
charges prepaid) to: Tripp
L i t e ,
418 W. Illinois, Chicago,
I L
60610. Seller
will pay
return shipping charges. Call Tripp Lite at (312) 755-5401 before
sending any equipment back for repair.
THIS
WARRANTY
DOES NOT APPLY TO NORMAL WEAR OR TO
DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR
NEGLECI: SELLER
MAKES
NO EXPRESS WARRANTIES OTHER
THAN
THE WARRANTY EXPRESSLY SET
FORT^
HEREIN.
EXCEPT
TO THE
EXTENT
PROHIBITED BY APPLICABLE LAW, ALL IMPLIED
WARRANTIES,
INCLUDING
ALL
WARRANTIES
OF
MERCHANTABILITY
OR FlTNJ3S, ARE LIMlTED IN DURATION TO
THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS
WARRANTY
EXPRESSLY EXCLUDES ALL INCIDENTAL AND
CONSEQUENTIAL DAMAGES. (Some states donot allow limitationson
how long an implied warranty lasts, and some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This Warranty
gives you specific legal rights, and you may have other rights whichvary
from jurisdiction to jurisdiction).
Tripp Lite
500 N.
Orleans
Chicago, IL
60610
WARNING:
The individual user should take
care
to determine prior to
use whether this device
is suitable, adequate or
safe for the use intended.
Since individual applications are subject to great variation, the
manufacturer makes no representation or w a -
to the suitability or
fitness of these devices for any specific application.
policy of ~
r
i
~
~
~ i t e i s one of continuous improvement. Specifications are
subject to change without notice.
3
@
Printed on
recycled paper
0295
-
Datashield
TR1pp&!E
7wEaJwm
~ a t a & ~ommunicatlon ~ i n e
Surge Suppressors
DataShield data/communication line surge suppressors are designed to protect
data and communications equipment against AC transients caused by lightning,
electrostatic discharge and ground surges that enter equipment from the signal
l i n e s or chassis ground.
DataShield surge suppressors described here protect virtually any
networked equipment using 10 baseT, 10 base-2 and 10 base5 Ethernet, Token
Ring, RS232, RS422/423/485,
dial-up modems, fax, T-1 lines and most other
communication interfaces.
Installation
To install the DataShield surge suppressor, follow these steps:
1. Make sure the computer, network device or other equipment is logged
OFF
the
network (if applicable).
Turn
OFF power to the equipment.
2.
D i s c o n n e c t the cable from the equipment to be protected.
!
3. Connect the DataShield surge suppressor directly to the equipment.
4. Attach the green ground
wire on the surge suppressor directly to the protected
equipment's chassis: (Datashield surge suppressors
with " D
style connectors do
not provide or require this external grounding).
5. Reconnect the cable to the DataShield surge suppressor.
NOTE!
The DataShield surge suppressor must
be properly grounded and
positioned
as
dose as
possible to the equipment to
be
protected. For best results, it
is
required that the length o f
the signal
line
and
ground wire
(if equipped)
between
the surge suppressor
and
the
protected equipment
be
kept
as
short
as
possible, not
to
exceed
12
inches ( 1 2 " ) .
It
i s best
to
install
the surge suppressor
directly to
the equipment,
as
noted above.
NOTE!
A singleDataShield surgesuppressor is equivalent to approximately three feet (3')
of typical data communidtion cable.
ACAUTIONI
When properly
installed,
the DataShield surge suppressor will protect against
surges
on
the dataline portion of your installation. Additional
AC
surge suppression/power
protectionin the form o f anISOBARmsurge suppressor
or
Tripp
Lite
UPSsystem isstrongly
recommended for complete system/network protection. Contact Tripp
Lite
Customer
Service
at (312) 755-5401
for more information.

Advertisement

loading

Summary of Contents for Tripp Lite DataShield 93-0163

  • Page 1 Tripp L i t e , 418 W. Illinois, Chicago, will pay return shipping charges. Call Tripp Lite at (312) 755-5401 before sending any equipment back for repair. WARRANTY THIS DOES NOT APPLY TO NORMAL WEAR OR TO...
  • Page 2 4 wires Calines) volts, protecting DCATV 750 amps Call Tripp Lite Customer Senrice at Tcnnlnal Strip, RS4221RS4231RS405 and ARCNm ~olullons. All surge ruppmron listed have component mponse timer of P u k P u l r Current Serial DB25 18 volts, protecting...

This manual is also suitable for:

Datashield