UAV Electronics SkyClip Operating Instructions

SKYCLIP – OPERATING INSTRUCTIONS
INSTRUCTIONS FOR USE

IMPORTANT

ALWAYS Use a Drop loop of .04mm diameter mono fishing line in
order for mechanism to release accurately at preset limit.
Tension force is preset at the factory to carry loads up to; 700gms for
Swellpro Spry+, 800grams for the DJI Mavic and 1200grams for DJI
Phantom when using 0.40mm line diameter. SkyClip will automatically
release the line when applied force is higher than tension preset limit.
Always install Skyclip in the middle of the drone for best weight
distribution and sensor avoidance.

INSTRUCTIONS

Always ensure you use a drop loop of no less 50cm with a standard
diameter line of .40mm in all situations for every cast. Insert/Clip the
line in the slot of the bait release until it locks in place.
Take-off the drone gently and reach a defined safety height of over 20
meters above sea level usually.
Fly the drone out over the water at maximum speed and make sure
that your line does not touch the water during the flight.(Keep the line
taught during flight – hold it in your hand) Once you reach the point
that you want to drop the bait, close the lever of the reel mechanism
so that the line stops bailing out – the line will release.
CAUTION
DO NOT slow down the drone and keep the speed constant until the
line releases automatically.
Finally bring back the Drone to Shore.