Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Xycom XVME-979
Summary of Contents for Xycom XVME-979
- Page 1 Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...
- Page 2 XVME-979 Mass Storage Module Ó Ó Ó Ó 2001 XYCOM, INC. Printed in the United States of America Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
- Page 3 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
- Page 4 Microsoft Corp. in the United States and other countries. Copyright Information This document is copyrighted by Xycom Incorporated (Xycom) and shall not be reproduced or copied without expressed written authorization from Xycom. The information contained within this document is subject to change without notice.
- Page 5 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
-
Page 6: Table Of Contents
XVME-977 purchased before May 13, 2001, Functional Rev 1.2................12 XVME-977 purchased after May 13, 2001, Functional Rev 1.3................12 P5 - External Floppy Drive Connector........................16 Configuring the XVME-979 ........................... 17 XVME-979 Switches .............................. 18 SL CD-ROM Adapter Switch Settings........................18 VMEbus Interface .............................. - Page 7 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
-
Page 8: Chapter One - Introduction
VMEbus systems. This module is built to communicate with Xycom’s XVME-65x and 66x VMEbus PC/AT processors. Power for the XVME-979 is provided by the P1 and P2 connectors. Signals are routed through P2. Figure 1-1 illustrates this in a block diagram of the XVME-979. -
Page 9: Interconnect Definition
XVME-979 Manual Interconnect Definition Signals from the CPU board to the XVME-979 travel via the P2 connector. The floppy drive connector is a 26-pin board mount connector that is accessible through the front panel. The hard drive plugs directly into a 50-pin right angle 2mm connector. The CD- ROM drive will be connected to a SL CDROM Interface Adapter Board. -
Page 10: Hardware Specifications
Chapter One - Introduction Hardware Specifications CD-ROM Drive Table 1-1 provides the hardware specifications for the CD-ROM Drive. Table 1-1 CD-ROM Drive Hardware Specifications Characteristic Specification Interface ATAPI/IDE Type 5.25 inch Speed Hard Drive Table 1-2 provides the hardware specifications for the hard drive. Table 1-2 Hard Drive Hardware Specifications Characteristic Specification... -
Page 11: Environmental Specifications
XVME-979 Manual Environmental Specifications Table 1-4 provides the environmental specifications for the XVME-979. Table 1-4 Environmental Specifications Characteristic Specification Humidity 20 to 80% RH, non-condensing Temperature Operating 5° to 50° C Ambient (41° to 122° F) Non-operating -40° to 65° C ambient (-0° to 149° F) -
Page 12: Chapter 2 - Installation
Installing into a VMEbus Card Cage The XVME-979 occupies only one double-high VMEbus slot, and fits into any standard 6U VMEbus card cage. Like all of Xycom’s modules, the XVME-979 is designed to comply with all electrical VMEbus backplane specifications. This module only draws current from the +5 volt power supply. -
Page 13: Xvme-977 Purchased Before May 13, 2001, Functional Rev 1.2
1. Remove the four hard disk drive mounting screws from the back of the XVME-977 and remove the hard disk drive. Connect the hard disk drive to the XVME-979/1 and install the hard disk drive mounting screws (that were removed from the XVME- 977) to the back of the XVME-979/1. - Page 14 Chapter Two - Installation Figure 2-1 depicts installation of the XVME-979 board. Figure 2-1. XVME-979/1 Installation (CD-ROM version only) To install the XVME-979/1 in a card cage: 1. Turn off power to the chassis. 2. Connect the jumper cable from the CPU slot to the XVME-977 slot on the rear of the P2 backplane, and then to the 979/1 slot as shown in Figure 2-1.
- Page 15 1. Turn off power to the chassis. 2. Connect the jumper cable from the CPU slot to the XVME-979 slot on the rear of the P2 backplane, as shown in Figure 2-1. This will bring the EIDE and floppy signals over from the CPU board to the XVME-979/2.
- Page 16 Make sure the floppy drive cable is able to reach the external floppy connector on the system before mounting. Model 9000-EXF External Floppy Drive Connects into the front of the XVME-979/2 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
-
Page 17: P5 - External Floppy Drive Connector
FDIRC* FHS* *The XVME-979 allows the 9000-EXF to be plugged in or unplugged under power. Be sure to remove the diskette before plugging in or unplugging the unit. Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com... -
Page 18: Configuring The Xvme-979
NOTE CD-ROM Legacy Support is supported in the XVME-660 BIOS, therefore the XVME-660 BIOS will recognize the XVME-979 CD-ROM and allow you to boot from the CD- ROM. The appropriate device drive will need to be loaded for general operation. -
Page 19: Xvme-979 Switches
(refer to figure 2, Connector and Switch Placement Diagram for the location of the switches). SW-1 and SW-2 provide hard drive configuration as defined by the drive manufacturer. The following switches are used in the XVME-979. The default is in bold print. SW-1 SW-2 Function description Drive is master;... -
Page 20: Vmebus Interface
Chapter Two - Installation VMEbus Interface The VMEbus connector provides power (+5 V and GND). The bus in and bus out are connected together, and the IACKIN* and IACKOUT* are connected together. P1 Connector BG0IN* BG0OUT* BG1IN* BG1OUT* BG2IN* BG2OUT* BG3IN* BG3OUT* IACKIN*... -
Page 21: P2 Connector
XVME-979 Manual P2 Connector HDRESET* HD10 HD11 HD12 HD13 HD14 HD15 PDIAG DIOW* DIOR* IDX* IORDY MO1* CABLE_SEL DMARQ* INTRQ (IRQ 14) FDS1* IOCS16* DMACK* FDIRC* FSTEP* FWD* CS1* FWE* CS3* FTK0* DASP* FWP* FHS* FRDD* DCHG* Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com... -
Page 22: P3 Cd-Rom Connector
Chapter Two - Installation P3 CD-ROM Connector Name Name IORDY DMACK* INTRQ (IRQ 14) RESETDRV* IOCS16* PDIAG DD10 CS1* CS3* DD11 DASP* DD12 DD13 DD14 DD15 DMARQ* CABLE_SEL DIOR* DIOW* Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com... -
Page 23: P4 Hard Drive Connector
XVME-979 Manual P4 Hard Drive Connector Signal Signal SW1 pin 8 SW1 pin 1 DMRQ* SW1 pin 7 SW1 pin 2 DIOW* DIOR* RESETDR IORDY CABLE_SEL DMACK* INTRQ (IRQ 14) IOCS16* DD10 PDIAG DD11 DD12 CS3* DD13 DASP* DD14 DD15... - Page 24 Chapter Two - Installation INDEX card cage installation Configuring the XVME-979 connectors floppy drive hard drive P119 P220 environmental specifications Environmental Specifications features, module floppy drive connector hardware specifications specifications, setting hard drive connector hardware specifications specifications, setting Hardware Specifications...
- Page 25 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
- Page 26 740979(C) Xycom Automation, Inc. Canada Sales: 905-607-3400 734-429-4971 • Fax: 734-429-1010 Northern Europe Sales: +44-1604-790-767 http://www.xycom.com Southern Europe Sales: +39-011-770-53-11 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
- Page 27 Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...
Need help?
Do you have a question about the XVME-979 and is the answer not in the manual?
Questions and answers