Onkyo TX-RZ3400 Instruction Manual page 165

„ 8. EQ for Standing Wave
This controls the affect of the standing waves that occur when sound waves
reverberating off obstacles such as walls interfere with the original sound waves.
Setting Item Default Value
Filter 1-3 0.0 dB
„ 9. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value
Speaker On
Virtualizer
Setting Details
1. After selecting the Filter to adjust from "Filter 1"
to "Filter 3" with / , press ENTER.
2. Select the frequency with / , then adjust
the attenuation with / . The frequency can
be selected between "63 Hz" and "250 Hz".
Attenuation can be selected between "0.0 dB"
and "12.0 dB" (0.5 dB intervals).
Setting Details
"On": Listening modes such as T-D that have virtual
speaker effects can be selected.
"Off": Listening modes such as T-D that have virtual
speaker effects cannot be selected.
Contents Connections
≫
3. Audio Adjust
„ 1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value
Multiplex Input Main
Channel
Mono Input Left + Right
Channel
Mono Output Center
Speaker
165
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit's display.
Set the input channel when playing in Mono
listening mode digital signals such as Dolby Digital
or analog/PCM signals recorded in 2 channels.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Set the speaker to output monaural audio in the
Mono listening mode.
"Center": Audio is output from the center speaker.
"Left/Right": Audio is output from the front L/R
speakers.
• If the item cannot be selected even though
connection is correct, check if the setting in
"2. Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected
channels.
≫