Advertisement
Quick Installation
Plug your UPS into an
1
electrical outlet.
Plug your computer,
2
monitor and external
modem into battery-
supported outlets. Plug
other equipment into
surge-only outlets.*
Set your UPS's "OFF –
3
ON" Switch.**
USA, Canada & Western Europe
· Set it and leave it "ON" at all times.
All Other Countries
· Set to "OFF" when you are not using
connected equipment.
(WARNING! When set to "OFF," UPS will not
provide battery backup during a blackout or
brownout)
· Set to "ON" when you are using
connected equipment.
* Separate battery-supported/surge and surge-only outlets are available only on select models (identified on the back of
your UPS). Your UPS is designed to support only computer equipment. You will overload your UPS if you connect
household appliances, laser printers or surge suppressors. ** See Basic Operation section for the Switch Function, UPS
Conditions and Setting Advantages.
–Optional Installation–
(select models)*
OPTION 1 (UPS Software)
Using Tripp Lite Cable (if supplied) connect
the DB9 port of your UPS to the DB9 port of
your computer. Load software (if supplied)
and run the installation program appropri-
ate for your operating system.
OPTION 2 (Brownout Voltage Adjustment)
Adjust the Voltage Potentiometer (UPS
back panel) clockwise to lower the voltage
point at which the UPS switches from on-
line to battery output.**
* Your UPS will function properly without these
connections or settings. ** For users who
experience frequent, severe brownouts to avoid
excessive battery drain. Note: Use caution when
adjusting the potentiometer while the UPS is
powering a voltage-sensitive load.
OPTION 1
OPTION 2
NORM
3
Advertisement
