Lenovo ThinkSystem 440-16e Installation And User Manual page 6

C3
C2
J18
C1
C0
Figure 1 Card Layout for the Thinksystem 440-16e SAS/SATA 12Gb Adapter
The following table describes the headers and connectors on the adapter.
Table 2 Headers and Connectors
Connector Type
J2 Standard edge card connector
J4 Default serial boot ROM (SBR) header 2-pin connector. Reserved.
J8 On-board serial UART connector
J18 (C0, Storage interface connectors
C1, C2, C3)
The following table describes the LEDs on the adapter.
Table 3 LED Designations
LED Type
LED 2 Yellow IOC over temperature
LED 3 Green system heartbeat
© Copyright Lenovo 2020
LED2
J2
Description
The interface between the storage adapter and the host system.
With the PCIe interface, this connector provides power to the board and an I
interface connected to the I
Interface (IPMI).
4-pin connector. Reserved.
Four SFF-8644 external connectors.
Connect the adapter by cable to the storage devices.
Description
Stays on solid to indicate that the SAS3816 device temperature sensor is over the
temperature threshold. When the device is in the proper temperature range, this LED is off.
Indicates that the SAS3816 IOC ASIC is operating normally. This LED blinks at 1 Hz.
ThinkSystem 440-16e SAS/SATA PCIe Gen4 12Gb HBA Installation and User Guide
LED3
J8
J4
3_04145-01
2
C bus for the Intelligent Platform Management
2
C
3